Toshiba TLP-MT7E manual Lamp replacement, Wait until the lamp gets cold enough, Bottom panel

68

Maintenance

Lamp replacement

The lamp will eventually begin to project dark
		1	Unplug the power cord.
or dull pictures and finally will not light up.
(Lamp’s life length depends on the use
condition.) In such a case, replace the lamp
with new one.	2		Wait until the lamp gets cold enough.
CAUTION

•If you use the projector mounted on the ceiling, ask the dealer to carry out the maintenance

•	such as cleaning or replacement of the lamp.	3	Take off the lamp cover on the
	When replacing, always use lamp “TLPLX10”		bottom panel.
	(sold separately). For detail, refer to the lamp
	instruction.		Loosen two screws, and pull off the lamp
•	If you have been using the projector, the lamp		cover.
			1
	will be very hot, and may cause burn injuries.
	Wait for the lamp to cool (for longer than 1		Lamp cover
			2
	hour) before replacing it.
•	If the lamp should break, please handle with
	care to avoid injury due to broken pieces and
	contact your dealer for repair service.

4		Pull out the lamp.
	1	Loosen the two fixing screws, and lift up the
		handle to pull out the lamp.
		2

Continued