2. MAJOR UNIT REPLACEMENT |
2.6Replacing the Head Up Sensor, Slit Sensor (Rewind/Feed) and Ribbon Motor (Rewind/Feed)
5)Push and release the hook A, then release the hook B to remove the slit sensor from the sensor holder.
Sensor Holder | Slit Sensor |
1
2
Hook A
1
Hook B
6)Replace the slit sensor with a new one, then reassemble in the reverse order of removal.
7)Perform a test print to print to confirm that the printer works properly.
NOTES:
1.The colors of the sensor harnesses are different according to the sensor to be connected.
2.Be careful not to damage the slit sensor (Rewind/Feed) when replacing it, as this may cause a malfunction.
2.6.3 Replacing the Ribbon Motor (Rewind/Feed)
1)Prior to replacing the ribbon motor, print out the maintenance counter for future reference.
2)Remove the
Ribbon Motor (Rewind) | |
|
Ribbon Motor (Feed) | |
|
3)Replace the ribbon motor with a new one, then reassemble in the reverse order of removal.