Toshiba B-852-R manual Major Unit Replacement

Page 17

2. MAJOR UNIT REPLACEMENT

EO18-33018

2.6 Replacing the Head Up Sensor, Slit Sensor (Rewind/Feed) and Ribbon Motor (Rewind/Feed)

NOTES:

1.After replacing the ribbon motor, refer to Section System Mode Manual to perform a Maintenance Counter clear.

2.Secure the ribbon motors while inserting a 0.1 mm-thick paper (or folded backing paper) between the ribbon motor pulley and the idler gear to adjust the backlash. After the ribbon motors is secured, remove the paper.

Ribbon Motor Pulley (Rewind)

Idler Gear

Ribbon Motor Pulley (Feed)

Idler Gear

4)Perform a test print to print to confirm that the printer works properly.

2-13

Image 17
Contents Series Table of Contents Unpacking ProcedureChecks Opening and Removing the Covers Major Unit ReplacementLubrication Replacing the Main PC Board Remove the two SMW-4x8 screws, SMW-3x6 screw and B-3x6 screw Main PC Board 3x6 Screw Main PCB Support Frame SMW-3x6 Replacing the Panel PC Board Major Unit Replacement Replacing the Stepping Motor Pulley Motor Gear Stepping Motor Replacing the Head Up Sensor Replacing the Slit Sensor Rewind/Feed Replacing the Ribbon Motor Rewind/Feed Major Unit Replacement Replacing the Platen Platen Shaft Holder Feed Gap Sensor TR and Black Mark Sensor Upper Side Replacing the Media SensorFeed Gap Sensor LED and Black Mark Sensor Lower Side Pass the media sensor harness between the harness guides Replacing the Print Head Replacing the PS Unit and Reactor Disconnect the PSU harness from CN4 on the PS unit Inlet Periodic Maintenance Procedure Periodic Maintenance Procedure Replacement Periodic Maintenance Procedure Troubleshooting Toshiba TEC