Toshiba B-570 manual Test Print Mode, Normal Test Print, I N T C O N D I T I O N, Pause key

6. DIAG. TEST OPERATION

EM18-33010A (Revision Date Feb. 07, ’97)

6.4 TEST PRINT MODE

6.4 TEST PRINT MODE

Test print mode contains normal test print and process test print.

6.4.1Normal Test Print

Five kinds of test prints are provided in the test print mode. When performing the test print, 7 parameters should be set. The default parameter at power on is as below:

∙ISSUE COUNT : 1

∙ PRINT SPEED	: 5 inch/sec.
∙ SENSOR	: Transmissive sensor
∙ RIBBON	: Transmissive ribbon
∙ TYPE	: Batch (without cut)

∙LABEL LENGTH : 76 mm

∙ PAPER FEED : Feed

Operating procedure for the test mode is provided below.

Power off

Turn on the power while holding down the [FEED] key and [PAUSE] key.

< 1 > D I A G N O S T I C V 1 . O A

Press the [FEED] key twice.

From C on the next page.

	< 3 > T E S T P R I N T
	Press the [PAUSE] key.
	P R I N T C O N D I T I O N
Press the [FEED] key
and [RESTART] key at		ISSUE COUNT	Press the	Press the
the same time.		PRINT SPEED
	Select "Print Condition"		[FEED] key or	[RESTART]
		SENSOR
	by pressing the		[RESTART]	key.
		RIBBON
	[PAUSE] key.		key.
		TYPE
Set the print count		LABEL LENGTH	(See NOTE 1.)	Continued
		PAPER FEED
				on section
			To A .
				6.4.2
	I S S U E C O U N T	1
				Process
				Test Print.
	To be continued on
	B of the next page.

6-41