Toshiba B-570 manual I N T S P E E D, N S O R T R a N S M I S S I V E

6. DIAG. TEST OPERATION

EM18-33010A

6.4 TEST PRINT MODE

From B of the preceding page.

	Set the print count from those at the		5000	(Print count 5000)
	right by pressing the	[FEED] key or	1000	(Print count 1000)
			500	(Print count 500)	Press the [FEED] key
	[RESTART] key. (See NOTE 2.)
			100	(Print count 100)
			50	(Print count 50)	and [RESTART] key
			10	(Print count 10)	at the same time.
			5	(Print count 5)
	Press the [PAUSE] key. (See NOTE 3.)
			3	(Print count 3)
Set the print speed			1	(Print count 1)	To C of the
					preceding page.
	P R I N T S P E E D	5 i n c h / s

Select the print speed from those at

the right by pressing the [FEED] 3 inch/sec.

key or [RESTART] key. 5 inch/sec. 8 inch/sec.

Press the [PAUSE] key. (See NOTE 3.)

Set the sensor type

Press the [FEED] key and [RESTART] key at the same time.

To C of the

preceding page.

S E N S O R T R A N S M I S S I V E

Select the sensor type from those at the right by pressing the [FEED] key or [RESTART] key. (See NOTE 2 and 4.)

NONE (consecutive form)

REFLECTIVE (black mark sensor)

TRANSMISSIVE (feed gap sensor)

Press the [FEED] key and [RESTART] key at the same time.

Press the [PAUSE] key. (See NOTE 3.)	To C of the
	preceding page.

Set the ribbon type

R I B B O N T R A N S M I S S I V E

Select the ribbon type from those at the right by pressing the [FEED] key or [RESTART] key. (See NOTE 2, 5 and 9.)

NO RIBBON

(No ribbon: Thermal direct)

TRANSMISSIVE (Transmissive ribbon: Thermal transfer)

NO TRANS. (Non-transmissive ribbon: Thermal transfer)

Press the [PAUSE] key. (See NOTE 3.)

To be continued on

B of the next page.

Press the [FEED] key and [RESTART] key at the same time.

To C of the preceding page.

6-42