Toshiba B-EV4 manual Replacing the Feed Gap Sensor Lower

Page 46

3. REPLACING THE IMPORTANT PARTS

EO18-33025

(Revision Date: Mar. 27, 2009)

3.12 Replacing the Feed Gap Sensor (Lower)

3.12Replacing the Feed Gap Sensor (Lower)

1.Refer to section 3.1 to remove the top cover.

2.Use the Phillips screwdriver to remove the 2 screws from the mylar sheet.

3.Remove the mylar sheet.

Mylar Sheet

FLT-3x6 Screw

4.Remove the sensor connector from the main PC board.

5.Use the Phillips screwdriver to remove the screw from the sensor plate.

6.Remove the sensor plate.

7.Remove the feed gap sensor (lower).

Main PC

Board

T-1.5x4 Screw

Sensor ConnectorSensor plate (JP29)

Feed Gap Sensor (lower)

8.Replace the feed gap sensor (lower) with a new one, then reassemble in the reverse order of removal.

3-24

Image 46

Contents EV4 Series Table of Contents Feature of the B-EV4D/EV4T Front ViewRear View InteriorEV4T Indication of the Model Name V 4 D G S 14 QM RBasic Specifications EV4D EV4TTUV External Media Holder B-EV904-PH-QM-R Key and LED Color StatusSupply Specifications Media TypeDetection Area of the Transmissive Sensor Detection Area of the Reflective SensorRibbon Figure below shows the effective print area on the mediaElectronic Specifications Block DiagramMain PC Board Layout U6 SdramDescription of the Main PC Board SdramDC/DC Converter U22 Type TS34063 JP2 SD Card Slot JP7 Serial Interface JP9 USB Type Type B Connector JP20 Ribbon End Sensor Print Head JP30 Replacing the Important Parts LubricationReplacing the Top Cover EV4T modelEV4D model Hook Media View Window Disconnect the connector from the feed button PC board Replacing the Lower Cover Replacing the Main PC Board Replacing the Important Parts Replacing the Platen Ass’y Replacing the Print Head Ass’y Remove the two screws which secure the print head ass’yConnector Print Head Ass’y Bracket Print Head Block Latch Top Inner Cover Remove the two pins which secure the print head ass’y Plate Replacing the Stepping Motor Lubrication Replacing the Gear Cover Replacing the Important Parts Replacing the Feed Button PC Board Replacing the Cover Open Sensor Replacing the Ribbon Sensor B-SV4T model only Replacing the Black Mark Sensor Remove the black mark sensorReplacing the Important Parts Replacing the Feed Gap Sensor Lower Replacing the Important Parts Replacing the Feed Gap Sensor Upper Remove the feed gap sensor upperReplacing the Important Parts Troubleshooting LED StatusPrint Quality Ribbon run out Loading the ribbonMaintenance Maintenance System Mode Abort of Label Format Auto Call Sensor Adjustment