Color monitor MCM 1755 NTD
Setting picture size, position, edges and color temperature
The picture size, position and edges have been set to optimum values at the factory for the preset operating modes (see "Technical data"). Depending on the monitor controller used, it may be necessary to change these settings. In this case you should change the settings.
You can change the colors by specifying a different color temperature.
The monitor can store up to 18 different display modes (including the predefined operating modes).
To make a setting, perform the following steps:
ÊPress the button for the function you want.
A window representing the function selected will then appear on the screen. The power lamp glows amber. While the power lamp is glowing amber the arrow buttons for the selected function are active.
ÊPress the arrow buttons (
, 
, 
or 
) until you have achieved the result you require.
All modifications are automatically stored if no button is pressed for several seconds. The window on the screen is then masked out and the power lamp once again glows green.
Adjusting the horizontal or vertical position
Press the Position button once.
Use the 
or 
button to shift the picture to the left or right.
Use the 
or 
button to shift the picture up or down.
Adjusting the horizontal or vertical size
Press the Size button once.
Use arrow button 
or 
to adjust the horizontal picture size.
Use the 
or 
button to adjust the vertical picture size.
Correcting
Press the Picture edges button once.
Use arrow button 
or 
to correct the
Use the 
or 
button to correct trapezium distortion.
Correcting tilt or parallelogram distortion
Press the Picture edges button twice.
Use arrow button 
or 
to correct the parallelogram distortion. Use the 
or 
button to correct the tilt distortion.
English - 17 |