Toshiba user manual Setup SR-M8102, Jumper Settings

SETUP – SR-M8102

The following steps must be performed to properly install your drive:

•Set Drive Jumper Settings

•Connect Audio Cable

•Attach IDE BUS Cable

•Attach Power Cable

•Mount Drive

Jumper Settings

The mode select jumpers are 6 straight angle pins located on the rear of the CD-R/CD-RW drive. By placing a jumper on the pins, you can select the following functions:

CS	Drive is configured using host interface signal CSEL
SL	Configures drive as Slave
MA	Configures drive as Master (default mode)
	Figure 1.Mode Select Jumper

In most installations, jumper should remain in the MA position (factory default). It is recommended that you install your CD-R/CD-RW drive only on the secondary IDE BUS. If you are installing on primary IDE BUS, your hard drive would then be the Master, and you should set your CD-R/CD-RW drive to the Slave position (SL)

Figure 2.Jumper Locations

3