Toshiba SR-M8102 user manual Placing CD-R/CD-RW Drive inside your Computer, Connecting Cables

Page 6

Placing CD-R/CD-RW Drive inside your Computer

Now that you have set the jumpers, you are ready to install your CD-R/CD-RW drive inside your computer.

Important Note: Disconnect power from your computer system before beginning installation.

Remove computer cover and faceplate if required. Refer to your computer systems manual for removal information. If the CD-R/CD-RW drive is replacing a CD-ROM or DVD-ROM, remove drive presently installed in your system.

Your Toshiba CD-R/CD-RW drive can be placed in any free half-height drive slot at the front of your computer. (It can be mounted horizontally or vertically.)

Carefully start sliding the CD-R/CD-RW drive into the opening with the disc tray facing the front of the computer. Before you push the drive all the way in you will need to connect the IDE BUS cable, Audio cable and the Power cable on the back of the drive.

Connecting Cables

IDE BUS Cable (not supplied with drive) - Your computer system should have a primary and secondary IDE BUS, cable with your Hard Drive most likely being the Master on the primary BUS. Connect BUS cable as follows, assuring that pin 1 of cable (side with red stripe) is connected to pin 1 of the CD-R/CD- RW drive's interface connector:

If you are replacing your CD-ROM or DVD:

Figure 3.Installing BUS Cable

connect CD-R/CD-RW drive to the BUS Cable connector

 

that the CD-ROM or DVD was connected to.

 

If CD-R/CD-RW drive is not replacing a CD-ROM/DVD

 

or is an addition to a CD-ROM/DVD:

 

connect CD-R/CD-RW drive to an open connector on

 

the secondary IDE BUS cable (not supplied with drive).

 

If CD-R/CD-RW drive is to be slave on Primary BUS:

 

connect CD-R/CD-RW drive to open connector on the

 

primary IDE BUS cable (not supplied with drive).

 

4

Image 6
Contents CD-R/CD-RW Drive Contents Introduction SR-M8102 Formats CompatibilityFront Panel Loading Tray Load/Unload Button Emergency Eject HoleSetup SR-M8102 Jumper SettingsConnecting Cables Placing CD-R/CD-RW Drive inside your ComputerInstalling Power Cable Completing InstallationDrive Operation Inserting a Disc Horizontally Inserting a Disc VerticallyUsage Guidelines Removing a DiscCD-RW Software Emergency EjectionUsing Emergency Eject Cleaning MediaTroubleshooting SR-M8102 SolutionSpecifications -SR-M8102 PerformancePower EnvironmentalPhysical Regulatory Connectors Drive Connectors -SR-M8102Connector AudioInterface Pin Assignments