Dell XPS410 manual Removing and Installing Parts, Removing the Computer Cover

Page 13

Back to Contents Page

Removing and Installing Parts

Dell™ XPS™ 410 Service Manual

Removing the Computer Cover

Inside View of Your Computer

System Board Components

Memory

Cards

Drive Panels

Drives

Hard Drive

Floppy Drive

Media Card Reader

CD/DVD Drive

Battery

Power Supply

Processor

I/O Panel

Processor Fan

Card Fan

System Board

Replacing the Computer Cover

This chapter provides procedures for removing and installing the components in your computer. Unless otherwise noted, each procedure assumes that the following conditions exist:

•You have performed the steps in Turning Off Your Computer and Before Working Inside Your Computer.

•You have read the safety information in your Dell™ Product Information Guide.

•A component can be replaced by performing the removal procedure in reverse order.

•You have the tools listed in Recommended Tools.

•You are familiar with Turning Off Your Computer.

When working inside the computer, be aware that the heat-sink assembly may be very hot during normal operation. Be sure that it has had sufficient time to cool before you touch it.

Removing the Computer Cover

CAUTION: Before you perform any of the procedures in this section, follow the safety instructions in the Product Information Guide.

CAUTION: To guard against electrical shock, always unplug your computer from the electrical outlet before removing the cover.

NOTICE: Before touching anything inside your computer, ground yourself by touching an unpainted metal surface, such as the metal at the back of the computer. While you work, periodically touch an unpainted metal surface to dissipate any static electricity that could harm internal components.

1.Follow the procedures in Before You Begin.

2.If you have installed a security cable, remove it from the security cable slot.

NOTICE: Ensure that sufficient space exists to support the removed cover—at least 30 cm (1 ft) of desk top space.

NOTICE: Ensure that you are working on a level, protected surface to avoid scratching either the computer or the surface on which it is resting.

3.Lay your computer on its side with the computer cover facing up.

4.Pull back the cover release latch on the top panel.

Page 12 Page 14
Image 13
Page 12 Page 14
Contents Model Dcta August 2006 Rev. A00 Front View of the Computer About Your ComputerBack View of the Computer Back Panel ConnectorsBack to Contents Power Lights Advanced TroubleshootingDiagnostic Lights Problem Description Suggested ResolutionCode Cause Beep CodesMessage Possible Cause Corrective Action System setup see Entering System SetupDell Diagnostics Main Menu Dell DiagnosticsOption Function Tab FunctionDrivers Reinstalling DriversIdentifying Drivers Click Start, then click Help and Support Resolving Software and Hardware IncompatibilitiesGetting Started Before You BeginRecommended Tools Turning Off Your ComputerBack to Contents Removing the Computer Cover Removing and Installing PartsSystem Board Components Inside View of Your ComputerMemory Overview MemoryAddressing Memory With 4-GB Configurations Installing MemoryPage Removing Memory CardsPCI Cards Page Page Removing a PCI Card PCI Express CardsPage Page Removing a PCI Express Card Removing the Drive Panel Drive PanelsRemoving the Drive-Panel Insert Installing the Drive-Panel InsertDrives Installing the Drive PanelHard Drive General Installation GuidelinesRemoving a Hard Drive Installing a Hard Drive Adding a Second Hard Drive Removing a Floppy Drive Floppy DriveMedia Card Reader Installing a Floppy DriveRemoving a Media Card Reader Installing a Media Card Reader CD/DVD Drive Installing a CD/DVD DriveRemoving a CD/DVD Drive Battery Replacing the Battery Power SupplyInstalling the Power Supply Removing the Power SupplyRemoving the Processor ProcessorInstalling the Processor Page Panel Components PanelRemoving the I/O Panel Page Installing the I/O Panel Removing the Processor Fan Processor FanCard Fan Installing the Processor FanSystem Board Installing the Card FanRemoving the Card Fan Removing the System BoardReplacing the Computer Cover Installing the System BoardBack to Contents Specifications Drives ConnectorsControls and Lights Physical PowerEnvironmental Entering System Setup System Setup ProgramSystem Setup Screens System Setup OptionsDrives Option Settings Boot SequenceChanging Boot Sequence for the Current Boot Clearing Forgotten PasswordsChanging Boot Sequence for Future Boots Clearing Cmos Settings Flashing the Bios Technical Overview Power Supply DC Connector Pin Assignments Signal Name Color Wire Gauge DC Power Connector P1DC Power Connect P4 DC Power Connector P2DC Power Connect P3, P5, P8, P9, P13, and P14 DC Power Connector P7DC Power Connector P12 DC Power Connectors P10
Related manuals
Manual 63 pages 47.98 Kb Manual 63 pages 48.17 Kb

XPS410, 410 specifications

The Dell XPS 410, launched in the mid-2000s, was a prominent desktop computer known for its robust performance and modern design. Targeting both enthusiasts and everyday users, the XPS 410 emerged as a reliable option for gaming, media, and general computing tasks.

One of the standout features of the XPS 410 was its sleek and stylish appearance, designed to complement contemporary home and office environments. It boasted a stylish chassis with an integrated lighting system, showcasing Dell's commitment to aesthetics alongside functionality.

The XPS 410 was powered by Intel's Core 2 Duo processor, which offered significant improvements in performance and energy efficiency over its predecessors. Depending on the configuration, users could choose from various processors, allowing for customization based on personal needs. This flexibility made the XPS 410 suitable for resource-intensive applications, such as photo editing, video rendering, and gaming.

Accompanying the powerful processor was a choice of memory options, with support for up to 4GB of DDR2 RAM. This ample memory capacity ensured smooth multitasking and efficient handling of demanding software. Users could also enhance performance through options for high-speed graphics cards, with dedicated GPUs from NVIDIA and ATI, catering to the needs of gamers and graphic designers alike.

In terms of storage, the XPS 410 offered various hard drive configurations, with SATA drives ranging from 250GB to 750GB, ensuring ample space for files, applications, and multimedia. Additionally, with options for RAID configurations, users could benefit from increased data redundancy and improved performance.

The XPS 410 also incorporated advanced technologies such as Dell's Media Center remote control compatibility, allowing for convenient navigation and control of media applications. The inclusion of multiple USB ports and card reader slots made it easy for users to connect a variety of peripherals, enhancing the overall functionality of the system.

Another noteworthy aspect of the XPS 410 was its ability to run Windows Vista, further emphasizing its appeal during a time of transition in consumer operating systems. The combination of powerful hardware and versatile software offerings made the XPS 410 a favored choice among professionals and gamers alike.

In summary, the Dell XPS 410 was a well-rounded desktop computer, featuring powerful processors, ample memory and storage options, and an appealing design. It catered to a wide variety of users, providing performance and versatility that stood out in its era.
Top Page Image Contents