Dell XE Removing the Chassis Intrusion Switch, Replacing the Chassis Intrusion Switch

Back to Contents Page

Chassis Intrusion Switch

Dell™ OptiPlex™ XE Service Manual—Small Form Factor

WARNING: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.

Removing the Chassis Intrusion Switch

NOTE: You may need to install Adobe® Flash® Player from Adobe.com in order to view the illustrations below.

1.Follow the procedures in Before Working Inside Your Computer.

2.Remove the hard-drive assembly.

3.Disconnect the chassis intrusion-switch cable from the system board.

4.Slide the chassis intrusion switch out of its slot in the metal bracket, and push it down to remove it from the computer.

Replacing the Chassis Intrusion Switch

To replace the chassis intrusion switch, perform the above steps in reverse order.

Back to Contents Page