Dell XE specifications Removing the Power Supply, Replacing the Power Supply

Page 34

Back to Contents Page

Power Supply

Dell™ OptiPlex™ XE Service Manual—Small Form Factor

WARNING: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.

Removing the Power Supply

NOTE: You may need to install Adobe® Flash® Player from Adobe.com in order to view the illustrations below.

1.Follow the procedures in Before Working Inside Your Computer.

2.Remove the optical drive.

3.Remove the hard drive.

4.Remove the back thermal sensor.

5.Remove the fan.

6.Disconnect the power cables from the system board.

7.Pull up the power supply release latch and slide the power supply toward the front of the computer.

8.Remove the power supply from the computer.

Replacing the Power Supply

To replace the power supply, perform the above steps in reverse order.

Back to Contents Page

Image 34

Contents Page System Setup Options System SetupEntering System Setup System Setup ScreenDisable No boot Disable EnableDisable Enable with PXE DisablePower On Deactivate defaultPower Off default Power On is set to disabledChanging the Boot Sequence for the Current Boot Boot SequenceOption Settings Enable F12 = Boot menu enabled by defaultBooting to a USB Device Password ProtectionAssigning a System Password If Password Status is set to LockedAdministrator Password Disabling a Forgotten Password and Setting a New PasswordClearing Forgotten Passwords Jumper SettingsJumper Setting Description Clearing Cmos Settings When to Use the Dell Diagnostics DiagnosticsDell Diagnostics Starting the Dell Diagnostics From Your Hard DrivePower Button Light Codes Beep CodesDiagnostic Lights Light Pattern Problem Description Suggested ResolutionBack to Contents Removing and Replacing Parts Memory SpecificationsProcessor VideoExpansion Bus NetworkSystem Information CardsSystem Board Connectors External ConnectorsControls and Lights Physical PowerEnvironmental Back to Contents System Board Layout Removing the Expansion Card Expansion CardReplacing the Expansion Card Removing the Coin-Cell Battery Coin-Cell BatteryReplacing the Coin-Cell Battery Removing the Cover CoverReplacing the Cover Removing the Fan FanReplacing the Fan Removing the Front Panel Front PanelReplacing the Front Panel Removing the Hard Drive Hard DriveReplacing the Hard Drive Removing the Heat Sink and Processor Heat Sink and ProcessorReplacing the Heat Sink and Processor Removing the Chassis Intrusion Switch Chassis Intrusion SwitchReplacing the Chassis Intrusion Switch Removing the Internal Speaker Internal SpeakerReplacing the Internal Speaker Removing the I/O Panel PanelReplacing the I/O Panel Removing the Memory MemoryReplacing the Memory Removing the Optical Drive Optical DriveReplacing the Optical Drive Removing the Power Supply Power SupplyReplacing the Power Supply Removing the System Board System BoardReplacing the System Board Replacing the Front Thermal Sensor Thermal SensorRemoving the Front Thermal Sensor Removing the Back Thermal SensorReplacing the Back Thermal Sensor Turning Off Your Computer Working on Your ComputerBefore Working Inside Your Computer Recommended ToolsAfter Working Inside Your Computer Click Start→ Turn Off Computer→ Turn Off