Adding Parts, Safety Instructions | Dell 8200 instruction

Back to Contents Page

Adding Parts

Dell™ Dimension™ 8200

Safety Instructions	Adding a Second Hard Drive
Shutting Down the Computer	Adding Other Drives
Reattaching the Front Door and Hinge Arms	Replacing the Microprocessor
Opening the Computer Cover	Removing the Front I/O Panel
Adding Cards	Replacing the Power Supply
Removing Cards	Replacing the System Board
Adding Memory	Closing the Computer Cover
Replacing an AGP Card

Safety Instructions

Use the following safety guidelines to help protect your computer from potential damage and to ensure your own personal safety.

When Using Your Computer

As you use your computer, observe the following safe-handling guidelines.

CAUTION: Do not operate your computer with any cover(s) (including computer covers, bezels, filler brackets, front-panel inserts, and so on) removed.

•Your computer is equipped with one of the following:

¡A fixed-voltage power supply — Computers with a fixed-voltage power supply do not have a voltage selection switch on the back panel and operate at only one voltage (see the regulatory label on the outside of the computer for its operating voltage).

¡An auto-sensing voltage circuit — Computers with an auto-sensing voltage circuit do not have a voltage selection switch on the back panel and automatically detect the correct operating voltage.

¡A manual voltage selection switch — Computers with a voltage selection switch on the back panel must be manually set to operate at the correct operating voltage.

To help avoid damaging a computer with a manual voltage selection switch, ensure that the voltage selection switch is set to match the AC power available at your location:

¡115 V/60 Hz in most of North and South America and some Far Eastern countries such as South Korea and Taiwan

¡100 V/50 Hz in eastern Japan and 100 V/60 Hz in western Japan

NOTE: The voltage selection switch must be set to the 115-V position even though the AC power available in Japan is 100 V.

¡230 V/50 Hz in some regions in the Caribbean and South America and most of Europe, the Middle East, and the Far East

Also, ensure that your monitor and attached devices are electrically rated to operate with the AC power available in your location.

•Before working inside the computer, unplug the computer to help prevent electric shock or system board damage. Certain system board components continue to receive power any time the computer is connected to AC power.

•To avoid shorting out your computer when disconnecting a network cable, first unplug the cable from the network adapter on the back of your computer, and then from the network jack. When reconnecting a network cable to your computer, first plug the cable into the network jack, and then into the network adapter.