Dell 8200 technical specifications Adding Other Drives

Page 17

b.Press in the two green rail tabs and pull the first hard drive out of the upper bay.

NOTICE: Do not install any drive into the lower hard-drive bay until after you have removed the green drive rails from the inside of the hard-drive cage.

c.Gently slide the first hard drive into the lower bay until you hear a click.

d.Reconnect the power cable and the data cable to the back of the first hard drive.

9.Gently slide the new hard drive into the upper bay until you hear a click.

NOTICE: Match the colored strip on the cable with pin 1 on the drive.

10.Locate the extra connector on the drive cable that is attached to your first hard drive, and attach the connector to the second hard drive.

HINT: Your computer uses cable-select drive cables. This means that the device connected to the end connector of the drive cable is the master device and the device connected to the middle connector is the slave device. Be sure the jumper setting on the new device is set for "cable select" (see the documentation that came with the drive for information).

11.Close the computer cover.

12.Connect your computer and devices to their electrical outlets, and turn them on.

NOTICE: To connect a network cable, first plug the cable into the network wall jack and then plug it into the computer.

13.See the documentation that came with the drive for instructions on installing any software required for drive operation.

Adding Other Drives

CAUTION: Before you begin any of the procedures in this section, follow the safety instructions in "Safety Instructions."

HINT: Drives sold by Dell come with their own operating software and documentation. After you install a drive, refer to the documentation that came with the drive for instructions on installing and using the drive software.

Image 17
Contents Abbreviations and Acronyms Dell DimensionHints, Notices, and Cautions System Codes and Messages Diagnostic CodesDiagnostic Code Definition Corrective Action System Messages Post Beep CodesBeep Codes Possible Cause Corrective Action Message Possible Cause Corrective ActionPost Printed Documentation DocumentationOnline Documentation Downloading the Tell Me How Help File and Associated FilesAdding Parts Safety InstructionsWhen Using Your Computer Protecting Against Electrostatic Discharge When Working Inside Your ComputerReattaching the Front Door and Hinge Arms Shutting Down the ComputerReattaching the Hinge Arms Adding Cards Opening the Computer CoverOpen the computer cover Close the computer cover Removing CardsRdram Overview Adding MemoryShut down the computer Replacing an AGP Card Adding a Second Hard Drive Adding Other Drives Inch Devices Inch Devices Replacing the Microprocessor Open the computer cover Installing the Microprocessor Removing the Front I/O Panel Replacing the Power SupplyRemoving the Power Supply Replacing the System Board Replacing the Power SupplyDimension 8200 System Board Types Removing the System Board Replacing the System Board Closing the Computer CoverALERT! Cover was previously removed Power Problems Solving ProblemsAccessing Help Files Video and Monitor Problems Start-Up Error MessagesAdjust the Windows display settings If the screen is blankPrinter Problems Sound and Speaker ProblemsIf you cannot print to a parallel port printer If you cannot print to a USB printerModem Problems Scanner ProblemsVerify that the modem is communicating with Windows Control Panel, double-clickPhone and Modem OptionsKeyboard Problems Mouse ProblemsDrive Problems Check the mouse settingsUnder Error-checking, click Check Now If you have a hard drive problemIf you cannot play a DVD movie If the CD-RW drive stops writingGeneral Program Problems Network ProblemsMicrosoft Windows Error Messages Resolving Other Technical Problems Internet Connection ProblemsMail Problems Using the Windows XP Device Driver Rollback Reinstalling DriversAt the Welcome Dell System Owner screen, click Next Click PropertiesWindows Resolving Software and Hardware IncompatibilitiesWindows Me Creating a Restore Point Using System RestoreUndoing the Last System Restore Reinstalling Windows XPClick Create a restore point Restoring the Computer to an Earlier Operating StateReinstalling Windows Me Click I accept the Agreement, and then click Next Reinstalling WindowsClick Next in the Welcome to Windows Me window Press Enter again to restart your computer Technical Specifications Audio2 PowerVideo Controls and LightsBack to Contents Viewing Settings System Setup ProgramSystem Setup Program Screens OverviewOption Function PXE BIS Clearing Forgotten PasswordsTechnical Overview Internal View System Board Connectors and SocketsSocketed Microprocessor Power SupplyPin Number Signal name 18-AWG Wire DC Power ConnectorsDC Power Connectors P3, P5, P6, P8, and P9 DC Power Connector P2DC Power Connector P7 Pin Number Signal Name 22-AWG WirePlacement of Dell-Installed Cards IDE Interface Cable Connections for Dell-Installed DrivesIDE Channel Connector Location Dell Installed Drive Card Connector Card DescriptionFront View Controls and LightsWindows Label Back ViewSerial Connector Hints, Notices, and Cautions Abbreviations and Acronyms
Related manuals
Manual 150 pages 39.74 Kb Manual 162 pages 52.76 Kb