Dell 8200 technical specifications Inch Devices

Page 19

10.Connect a power cable to the drive.

See the documentation that came with the drive for instructions on connecting a drive cable to the drive and system board.

HINT: Your computer uses cable-select drive cables. This means that the device connected to the end connector of the drive cable is the master device and the device connected to the middle connector is the slave device. Be sure the jumper setting on the new device is set for "cable select" (see the documentation that came with the drive for information).

11.Close the computer cover.

12.Connect your computer and devices to their electrical outlets, and turn them on.

NOTICE: To connect a network cable, first plug the cable into the network wall jack and then plug it into the computer.

See the documentation that came with the drive for instructions on installing any software required for drive operation.

3.5-Inch Devices

CAUTION: Before you begin any of the procedures in this section, follow the safety instructions in "Safety Instructions."

1.Shut down the computer.

2.Turn off any attached devices and disconnect them from their electrical outlets.

NOTICE: To disconnect a network cable, first unplug the cable from your computer and then unplug it from the network wall jack.

3.Disconnect the power cable from your computer, and then press the power button to ground the system board.

4.Unpack the drive and prepare it for installation.

See the documentation that came with the drive to ensure that the drive is set up for your computer.

5.Open the computer cover.

6.To remove the drive-bay cover panel, carefully press the panel out from the inside of the computer.

7.To remove the drive-bay cover panel insert, press the four securing tabs and pull the insert away from the panel.

HINT: Two sets of rails are attached to the inside of the computer cover. Use the two longer rails on 5.25-inch drives. Use the shorter rails for 3.5-inch drives. Rails for a second hard drive are attached inside the hard-drive cage.

Image 19
Contents Hints, Notices, and Cautions Dell DimensionAbbreviations and Acronyms Diagnostic Code Definition Corrective Action Diagnostic CodesSystem Codes and Messages Message Possible Cause Corrective Action Post Beep CodesSystem Messages Beep Codes Possible Cause Corrective ActionPost Downloading the Tell Me How Help File and Associated Files DocumentationPrinted Documentation Online DocumentationWhen Using Your Computer Safety InstructionsAdding Parts Protecting Against Electrostatic Discharge When Working Inside Your ComputerReattaching the Front Door and Hinge Arms Shutting Down the ComputerReattaching the Hinge Arms Adding Cards Opening the Computer CoverOpen the computer cover Close the computer cover Removing CardsRdram Overview Adding MemoryShut down the computer Replacing an AGP Card Adding a Second Hard Drive Adding Other Drives Inch Devices Inch Devices Replacing the Microprocessor Open the computer cover Installing the Microprocessor Removing the Power Supply Replacing the Power SupplyRemoving the Front I/O Panel Dimension 8200 System Board Types Replacing the Power SupplyReplacing the System Board Removing the System Board Replacing the System Board Closing the Computer CoverALERT! Cover was previously removed Accessing Help Files Solving ProblemsPower Problems If the screen is blank Start-Up Error MessagesVideo and Monitor Problems Adjust the Windows display settingsIf you cannot print to a USB printer Sound and Speaker ProblemsPrinter Problems If you cannot print to a parallel port printerControl Panel, double-clickPhone and Modem Options Scanner ProblemsModem Problems Verify that the modem is communicating with WindowsCheck the mouse settings Mouse ProblemsKeyboard Problems Drive ProblemsIf the CD-RW drive stops writing If you have a hard drive problemUnder Error-checking, click Check Now If you cannot play a DVD movieMicrosoft Windows Error Messages Network ProblemsGeneral Program Problems Mail Problems Internet Connection ProblemsResolving Other Technical Problems Click Properties Reinstalling DriversUsing the Windows XP Device Driver Rollback At the Welcome Dell System Owner screen, click NextWindows Me Resolving Software and Hardware IncompatibilitiesWindows Creating a Restore Point Using System RestoreRestoring the Computer to an Earlier Operating State Reinstalling Windows XPUndoing the Last System Restore Click Create a restore pointReinstalling Windows Me Click Next in the Welcome to Windows Me window Reinstalling WindowsClick I accept the Agreement, and then click Next Press Enter again to restart your computer Technical Specifications Controls and Lights PowerAudio2 VideoBack to Contents Overview System Setup ProgramViewing Settings System Setup Program ScreensOption Function PXE BIS Clearing Forgotten PasswordsTechnical Overview Internal View System Board Connectors and SocketsSocketed Microprocessor Power SupplyPin Number Signal name 18-AWG Wire DC Power ConnectorsPin Number Signal Name 22-AWG Wire DC Power Connector P2DC Power Connectors P3, P5, P6, P8, and P9 DC Power Connector P7Card Connector Card Description IDE Interface Cable Connections for Dell-Installed DrivesPlacement of Dell-Installed Cards IDE Channel Connector Location Dell Installed DriveFront View Controls and LightsWindows Label Back ViewSerial Connector Hints, Notices, and Cautions Abbreviations and Acronyms
Related manuals
Manual 150 pages 39.74 Kb Manual 162 pages 52.76 Kb