Dell 9100 specifications Drives, Replacing the Drive Panel, Connecting Drive Cables

Page 20

3. Ensure that the drive-panel insert is correctly seated in the drive panel.

Replacing the Drive Panel

1. Follow the procedures in "Before You Begin."

2.Align the drive panel tabs with the side-door hinges.

3.Rotate the drive panel toward the computer until the sliding plate lever clicks into place and the drive panel snaps into place on the front panel.

Drives

Your computer supports:

•Two hard drives (Serial ATA)

•One floppy drive

•One flexbay drive

•Two CD or DVD drives

Connecting Drive Cables

When you install a drive, you connect two cables—a DC power cable and a data cable—to the back of the drive and to the system board. Some CD/DVD drives may also have an audio connector; one end of the audio cable will attach to the drive connector and the other will attach to the system board.

Connect hard drives to data connectors labeled "SATA" and connect CD/DVD drives to connectors labeled "IDE".

Image 20

Contents Model Dcta April 2005 Rev. A00 Back to Contents About Your ComputerFront View of the Computer Front View of the Computer Back View of the ComputerBack View of the Computer Advanced Troubleshooting Power LightsDiagnostic Lights Power Lights Diagnostic Lights Beep CodesCode Cause Beep CodesMemory Program, enter the system setup Enter the system setup program, verifyMessage Possible Cause Corrective Action Reseat the memory modulesEnter the system setup program Before You Begin Getting StartedRecommended Tools Turning Off Your ComputerBack to Contents Replacing the Computer Cover Removing the Computer Cover Memory Overview Removing and Installing PartsMemory Installing Memory Remove the computer coverCards Removing MemoryRemoving and Installing PCI and PCI Express Cards Page Page Removing the Drive Panel Network Adapter and Sound Card SettingsDrive Panels Removing the Drive-Panel Insert Replacing the Drive-Panel InsertReplacing the Drive Panel Connecting Drive CablesDrives Removing a Hard Drive Drive Interface ConnectorsHard Drive Installing a Hard Drive Adding a Second Hard Drive Replace the computer cover Floppy DriveRemoving a Floppy Drive Installing a Floppy Drive Media Card Reader Removing a Media Card ReaderInstalling a Media Card Reader Removing a CD/DVD Drive Installing a CD/DVD DriveCD/DVD Drive Power Supply Removing the Power SupplyReplacing the Power Supply ProcessorRemoving the Processor Installing the Processor Page Removing the I/O Panel PanelPanel Components Page Replacing the I/O Panel BatteryReplacing the Battery System Board Removing the System BoardReplacing the System Board Model Dcta April 2005 Rev. A00 Specifications Connectors PowerDrives Controls and LightsPhysical EnvironmentalSystem Setup Entering System SetupSystem Setup Options Clearing Forgotten Passwords Clearing Cmos SettingsProcessor has 64-bit Technology DrivesBoot Sequence SecurityClearing Forgotten Passwords Enter system setupOpen the computer cover Clearing Cmos SettingsClose the computer cover Technical Overview Inside View of Your Computer System Board ComponentsPower Supply DC Connector Pin Assignments DC Power Connector P1DC Power Connector P2 DC Power Connect P3 and P5Pin Number Signal Name Color Wire Gauge Pin Number Signal Name 18-AWG WireDC Power Connector P4 DC Power Connector P7DC Power Connectors P8, P9, and P10 DC Power Connector P11DC Power Connector P12

Related manuals

Manual 162 pages 20.69 Kb

Manual 83 pages 12.96 Kb