Dell 9100 specifications Enter the system setup program

Page 7

	system board failed to POST.	to be replaced.
INTR2 Error
Invalid Boot	The operating system cannot	Enter the system setup program and
Diskette	be located on drive A or drive	confirm that drive A or drive C is properly
	C.	identified.
Keyboard Error	The BIOS has detected a	Ensure that nothing is resting on the
	stuck key.	keyboard; if a key appears to be stuck,
		carefully pry it up. If the problem
		persists, you may need to replace the
		keyboard.

KB/Interface	An error occurred with the	Ensure that nothing is resting on the
Error	keyboard connector.	keyboard; if a key appears to be stuck,
		carefully pry it up. If the problem
		persists, you may need to replace the
		keyboard.

No ROM Basic	The operating system cannot	Enter the system setup program and
	be located on drive A or drive	confirm that drive A or drive C is properly
	C.	identified.

Back to Contents Page

Image 7

Contents Model Dcta April 2005 Rev. A00 Front View of the Computer Back View of the Computer Back to ContentsAbout Your Computer Front View of the ComputerBack View of the Computer Power Lights Diagnostic Lights Beep Codes Advanced TroubleshootingPower Lights Diagnostic LightsMemory Beep CodesCode Cause Reseat the memory modules Program, enter the system setupEnter the system setup program, verify Message Possible Cause Corrective ActionEnter the system setup program Turning Off Your Computer Before You BeginGetting Started Recommended ToolsBack to Contents Replacing the Computer Cover Removing the Computer Cover Memory Removing and Installing PartsMemory Overview Remove the computer cover Installing MemoryRemoving Memory CardsRemoving and Installing PCI and PCI Express Cards Page Page Drive Panels Network Adapter and Sound Card SettingsRemoving the Drive Panel Replacing the Drive-Panel Insert Removing the Drive-Panel InsertDrives Connecting Drive CablesReplacing the Drive Panel Hard Drive Drive Interface ConnectorsRemoving a Hard Drive Installing a Hard Drive Adding a Second Hard Drive Removing a Floppy Drive Floppy DriveReplace the computer cover Installing a Floppy Drive Removing a Media Card Reader Media Card ReaderInstalling a Media Card Reader CD/DVD Drive Installing a CD/DVD DriveRemoving a CD/DVD Drive Removing the Power Supply Power SupplyProcessor Replacing the Power SupplyRemoving the Processor Installing the Processor Page Panel Components PanelRemoving the I/O Panel Page Replacing the Battery BatteryReplacing the I/O Panel Removing the System Board System BoardReplacing the System Board Model Dcta April 2005 Rev. A00 Specifications Controls and Lights ConnectorsPower DrivesEnvironmental PhysicalClearing Forgotten Passwords Clearing Cmos Settings System SetupEntering System Setup System Setup OptionsDrives Processor has 64-bit TechnologySecurity Boot SequenceEnter system setup Clearing Forgotten PasswordsClose the computer cover Clearing Cmos SettingsOpen the computer cover Inside View of Your Computer System Board Components Technical OverviewDC Power Connector P1 Power Supply DC Connector Pin AssignmentsPin Number Signal Name 18-AWG Wire DC Power Connector P2DC Power Connect P3 and P5 Pin Number Signal Name Color Wire GaugeDC Power Connector P11 DC Power Connector P4DC Power Connector P7 DC Power Connectors P8, P9, and P10DC Power Connector P12

Related manuals

Manual 162 pages 20.69 Kb

Manual 83 pages 12.96 Kb