Dell 9100 specifications Removing a CD/DVD Drive, Installing a CD/DVD Drive

Page 28

10.Replace the computer cover.

CD/DVD Drive

CAUTION: Before you begin any of the procedures in this section, follow the safety instructions in the Product Information Guide.

CAUTION: To guard against electrical shock, always unplug your computer from the electrical outlet before opening the cover.

Removing a CD/DVD Drive

1.Follow the procedures in "Before You Begin."

2.Remove the computer cover.

3.Disconnect the power cable from the back of the drive and the CD/DVD drive cable from the back of the drive and the system board.

4. Slide the drive release mechanism to the right to release the shoulder screw and slide the drive out to remove it from the drive bay.

Installing a CD/DVD Drive

1.If you are installing a new drive, unpack the drive and prepare it for installation.

Check the documentation that accompanied the drive to verify that the drive is configured for your computer. If you are installing an IDE drive, configure the drive for the cable select setting.

2.If you are installing a new drive, remove the three shoulder screws from the inside of the drive- panel insert and attach the screws to the new drive.

Image 28

Contents Model Dcta April 2005 Rev. A00 Back to Contents About Your ComputerFront View of the Computer Front View of the Computer Back View of the ComputerBack View of the Computer Advanced Troubleshooting Power LightsDiagnostic Lights Power Lights Diagnostic Lights Beep CodesMemory Beep CodesCode Cause Program, enter the system setup Enter the system setup program, verifyMessage Possible Cause Corrective Action Reseat the memory modulesEnter the system setup program Before You Begin Getting StartedRecommended Tools Turning Off Your ComputerBack to Contents Replacing the Computer Cover Removing the Computer Cover Memory Removing and Installing PartsMemory Overview Installing Memory Remove the computer coverCards Removing MemoryRemoving and Installing PCI and PCI Express Cards Page Page Drive Panels Network Adapter and Sound Card SettingsRemoving the Drive Panel Removing the Drive-Panel Insert Replacing the Drive-Panel InsertDrives Connecting Drive CablesReplacing the Drive Panel Hard Drive Drive Interface ConnectorsRemoving a Hard Drive Installing a Hard Drive Adding a Second Hard Drive Removing a Floppy Drive Floppy DriveReplace the computer cover Installing a Floppy Drive Media Card Reader Removing a Media Card ReaderInstalling a Media Card Reader CD/DVD Drive Installing a CD/DVD DriveRemoving a CD/DVD Drive Power Supply Removing the Power SupplyReplacing the Power Supply ProcessorRemoving the Processor Installing the Processor Page Panel Components PanelRemoving the I/O Panel Page Replacing the Battery BatteryReplacing the I/O Panel System Board Removing the System BoardReplacing the System Board Model Dcta April 2005 Rev. A00 Specifications Connectors PowerDrives Controls and LightsPhysical EnvironmentalSystem Setup Entering System SetupSystem Setup Options Clearing Forgotten Passwords Clearing Cmos SettingsProcessor has 64-bit Technology DrivesBoot Sequence SecurityClearing Forgotten Passwords Enter system setupClose the computer cover Clearing Cmos SettingsOpen the computer cover Technical Overview Inside View of Your Computer System Board ComponentsPower Supply DC Connector Pin Assignments DC Power Connector P1DC Power Connector P2 DC Power Connect P3 and P5Pin Number Signal Name Color Wire Gauge Pin Number Signal Name 18-AWG WireDC Power Connector P4 DC Power Connector P7DC Power Connectors P8, P9, and P10 DC Power Connector P11DC Power Connector P12

Related manuals

Manual 162 pages 20.69 Kb

Manual 83 pages 12.96 Kb