D-Link WBR-1310 manual Administrator Settings, IP Address Port

Section 3 - Configuration

Administrator Settings

This page will allow you to change the Administrator and User passwords. You can also enable Remote Management. There are two accounts that can access the management interface through the web browser. The accounts are admin and user. Admin has read/write access while user has read-only access. User can only view the settings but cannot make any changes. Only the admin account has the ability to change both admin and user account passwords.

Administrator

Login Name:

Administrator

Password:

User Login Name:

User Password:

Remote Management:

IP Address:

Port:

Enter a new Login Name for the Administrator account.

Enter a new password for the Administrator Login Name. The administrator can make changes to the settings.

Enter a new Login Name for the user account.

Enter the new password for the User login. If you login as the User, you can only see the settings, but cannot change them.

Remote management allows the WBR-1310 to be configured from the Internet by a web browser. A username and password is still required to access the Web-Management interface. In general, only a member of your network can browse the built-in web pages to perform Administrator tasks.This feature enables you to perform Administrator tasks from the remote (Internet) host.

The Internet IP address of the computer that has access to the Broadband Router. If you input an asterisk (*) into this field, then any computer will

be able to access the Router. Putting an asterisk (*) into this field would present a security risk and is not recommended.

The port number used to access the WBR-1310.

Example: http://x.x.x.x:8080 whereas x.x.x.x is the WAN IP address of the WBR-1310 and 8080 is the port used for the Web-Management interface.

D-Link WBR-1310 User Manual 35