D-Link DSL-2740B manual Rear Panel Connections, Connect network cables

DSL-2740B Wireless ADSL Router User Guide

Rear Panel Connections

All cable connections to the Router are made at the rear panel. Connect the power adapter here to power on the Router. Use the Reset button to restore the settings to the factory default values in the next chapter for instructions on using the reset button).

Connect network cables:

1.Insert the ADSL (telephone) cable included with the Router into the ADSL port and then connect the cable to your telephone line.

2.Insert one end of the Ethernet cable into one of the LAN ports on the back panel of the Router and the other end of the cable to an Ethernet Adapter or available Ethernet port on your computer.

Antenna

For wireless operation, mount the antenna on the threaded antenna post.

Note

ADSL port

Use the ADSL cable to connect to the your telephone line (RJ-11 port)

Ethernet ports

Use the Ethernet ports to connect the Router to your Ethernet LAN or Ethernet devices

To manually reboot the Router, disconnect and then reconnect the power.

Reset button

To manually reset, depress button with the power on for at least seven seconds

Power insert	Power button
Use the adapter	Push in to power-on
shipped with the	the Router. Push
Router to connect	again to power-off
to power source	the Router

Using a power supply with a different voltage rating will damage the device and void

WARNING! the warranty of this product.

5