D-Link DI-304M manual FCC Warning, CE Mark Warning

Page 2

Copyright Statement

Copyright ©2002 D-Link Corporation

No part of this publication may be reproduced in any form or by any means or used to make any derivative such as translation, transformation, or adaptation without permission from D-Link Corporation/D-Link Systems Inc., as stipulated by the United States Copyright Act of 1976.

Trademarks

D-Link is a registered trademark of D-Link Corporation/D-Link Systems, Inc.

All other trademarks belong to their respective owners.

FCC Warning

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

•Reorient or relocate the receiving antenna.

•Increase the separation between the equipment and receiver.

•Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

•Consult the dealer or an experienced radio/TV technician for help.

Shielded interface cables must be used in order to comply with emission limits.

You are cautioned that changes or modifications not expressly approved by the party responsible for compliance could void your authority to operate the equipment.

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

CE Mark Warning

This is a Class B product. In a domestic environment, this product may cause radio interference in which case the user may be required to take adequate measures.

Image 2

Contents DI-304/DI-304M Isdn Router User’s Guide FCC Warning CE Mark WarningSoftware Link Offices for Registration and Warranty ServiceHardware Page Wichtige Sicherheitshinweise Table of Contents Virtual TA Application Appendix C IP Protocol and Port Numbers Product Features IntroductionIsdn Basic Rate Interface BRI Ease of InstallationBuilt-in Switch Standard Phone Jacks Just for DI-304MRemote Access Server RAS Dhcp Support Dynamic Host Configuration ProtocolFirmware Upgrade Tftp Server Networking CompatibilityApplications for your DI-304/DI-304M LAN-to-LAN Enterprise Connections What This Manual CoversNetwork Address Translation NAT Remote Dial-In ServerPacking List What This Manual Doesn’t CoverOther Resources Additional Installation Requirements Ordering Your Isdn Line Installation & SetupBefore You Start Web Configurator Factory Default Settings Default IP Network SettingsDhcp Server Enabled DI-304/DI-304M Front PanelDI-304 DI-304M DI-304/DI-304M Rear Panel Connecting to the Ethernet Hardware InstallationConnecting the Power Adapter Setting Up a Management PC Connecting to an Isdn BRI LineConnecting to a DSL/Cable Modem T-Interface ModelChecking the Network IP Configuration Click the Add button. The Select Network ComponentConfiguring the TCP/IP Protocol Checking TCP/IP Settings DI-304/DI-304M Isdn Remote Router Using the Smart Start Wizard Installing the Router ToolsDI-304/DI-304M Isdn Remote Router DI-304/DI-304M Isdn Remote Router DI-304/DI-304M Isdn Remote Router Using the Web Configurator Connecting to the Web Configurator via a Web BrowserQuick Setup Overview of the Web ConfiguratorBasic Setup Setup First Advanced Setup System ManagementDI-304/DI-304M Isdn Remote Router Configuring Ethernet TCP/IP Address and Dhcp Server Basic Configuration and Internet AccessChanging the Administrator Password Dhcp Server Configuration Router IP Network Configuration For NAT UsageFor IP Routing Usage Default Disable Configuring the Isdn Interface Dialing to a Single ISP Internet Access SetupIsdn Dial-up Internet Access ISP Access Setup PPP/MP SetupIP Address Assignment Method Ipcp Dialing to Dual ISPsIP Address Assignment Method Icpc SetupDSL/Cable Modem Internet Access Using PPPoE with a DSL Modem PPPoE SetupIsdn Dial Backup Setup Using Pptp with a DSL Modem Pptp SetupUsing a Static IP with a DSL/Cable Modem Isdn Dial Backup Setup There are three options Access ControlConfiguring Isdn Dial Backup DI-304/DI-304M Isdn Remote Router Remote Access Remote Dial-In AccessCreating an Access Account for a Dial-in User IP Address Assignment for Dial-In UsersCallback Function LAN-to-LAN Access Head Office Dial-In Service Enable Start IP Address Branch OfficeActivating the Remote Dial-In Capability Dial-In Service Enable Start IP Address Creating a LAN-to-LAN Dialer ProfileDI-304/DI-304M Isdn Remote Router Dial-In Settings Common SettingsDial-Out Settings TCP/IP Network Settings Branch Office DI-304/DI-304M Isdn Remote Router Advanced Setup Enabling the Remote Activation FunctionPPP/MP Dial-Out Setup Call Control SetupDial Retry and Dial Delay Interval Basic SetupBandwidth On Demand BOD Setup Call Schedule Setup NAT Setup DMZ Host Setup Open Ports Setup Well-known Port Number List Static Route Setup IP Filter/Firewall SetupAn Overview of the Firewall General Setup DI-304/DI-304M Isdn Remote Router DI-304/DI-304M Isdn Remote Router Check to enable the Filter Rule Enable the filter rule Editing the Filter RulesDI-304/DI-304M Isdn Remote Router Restricting Unauthorized Internet Services Virtual TA Concepts Quick Setup Virtual TA Remote Capi SetupVirtual TA Application Installing a Virtual TA Client Configuring a Virtual TA Client/ServerCreating a User Profile Virtual TA ServerVirtual TA User Profiles Configuring the MSN Number System ManagementOnline Status Isdn StatusWAN Status Time SetupLAN Status Management Setup Management Port Setup Snmp SetupDiagnostic Tools ISDN/PPPoE/PPTP DiagnosticsBroadband Access Triggered Dial-out Packet HeaderView Routing Table View ARP Cache Table View Dhcp Assigned IP AddressesView NAT Port Redirection Running Table View NAT Active Sessions TableSysLog Setting Reboot System Firmware Upgrade DI-304/DI-304M Isdn Remote Router Appendix a Troubleshooting and FAQs Using the Telnet Terminal CommandsQuitting the Telnet Terminal Command HelpRecall Commands Viewing Call LogsViewing PPP Logs Viewing Isdn LogsDetailed Isdn log example Viewing WAN LogsWhy does the router dial out very often? FAQsWhat is the default IP address of the router? Why cant I connect to the Web Configurator?Appendix B Basic IP Concepts IP AddressesIP Network Classes Subnet Mask IP Port Numbers Appendix C IP Protocol and Port NumbersIP Protocol Numbers Appendix D Technical Specifications GeneralCTR-3 Index PPP/MPOffices Norway Link Norway Registration Card