DI-304/DI-304M ISDN Remote Router
♦RX Pkts – Total number of received IP packets received during this connection session.
♦RX Rate – Reception rate for ingoing data. The unit is characters per second (cps).
♦Up Time – Connection time. The format is HH:MM:SS where HH means hours, MM means minutes, and SS means seconds.
♦AOC – The Advice of Charge (AOC) service allows you to view information concerning charges for a call.
♦Drop B1 – Click to disconnect the B1 channel.
♦Drop B2 – Click to disconnect the B2 channel.
LAN Status
♦IP Address – IP address of the LAN interface.
♦TX Packets – Total number of transmitted IP packets send since the router was powered on.
♦RX Packets – Total number of transmitted IP packets received since the router was powered on.
WAN Status
♦Mode – Indicates which broadband access mode is active. Depending upon the broadband access mode, you may see Static IP, PPTP, or PPPoE.
♦GW IP Address – Indicates the gateway IP address.
♦IP Address – The 2nd IP Address of Ethernet or the IP address of WAN interface that is from PPTP/PPPoE connection.
♦TX Packets – Total number of transmitted IP packets sent during this connection session.
♦TX Rate – Transmission rate for outgoing data. The unit is characters per second (cps).
♦RX Packets – Total number of transmitted IP packets received during this connection session.
♦RX Rate – Reception rate for ingoing data. The unit is characters per second (cps).
♦Up Time – Connection time. The format is HH:MM:SS where HH means hour, MM means minute, and SS means second.
♦Drop PPPoE or PPTP – Click to disconnect the PPPoE or PPTP connection.
Time Setup
Click Time Setup to open a page that allows you to make configuration changes to the time setup.
71