DI-304/DI-304M ISDN Remote Router
♦Enable CLID Authentication – Limit the
♦Peer ISDN Number – If CLID Authentication is enabled, enter the remote router's ISDN number in this field
♦Link Type – Refer to
♦PPP Authentication – Refer to
♦VJ Compression – Refer to
♦Callback Function (CBCP) – Checking here allows this router to accept requests from a remote router for call back.
◊Enable Callback Function - Checking here to enable this function. The router owner will be charged the connection fee by the telecom.
◊Use the Following Number to Callback:
-Callback Number: Check here and enter a callback number for the router to call.
-Callback Budget: Specify a time budget for the callback function. By default the budget is set to zero, which means no call back attempt will work.
TCP/IP Network Settings
The following settings are required for proper
♦My WAN IP – In most cases you may accept the default value in this field. The router will then get a WAN IP address from the remote router during the IPCP negotiation phase. If the WAN IP address is fixed by remote, specify the fixed IP address here.
♦Remote Gateway IP – Specify the IP address of the remote router.
♦Remote Network IP – Specify the network identification of the remote network. For example, 192.168.1.0 is a network identification of a
♦Remote Network Mask – Specify the netmask of the remote network.
♦RIP Direction – The option specify the direction of RIP (Routing Information Protocol) packets through the ISDN WAN connection.
♦RIP Version – Select the RIP protocol version. Specify Ver. 2 for greatest compatibility.
♦For NAT operation, treat remote
Recall the
Head Office:
47