D-Link DIR-625 manual L2TP

Page 23

Section 3 - Configuration

Internet Setup

L2TP

Choose L2TP (Layer 2 Tunneling Protocol) if your ISP uses a L2TP connection.Your ISP will provide you with a username and password. This option is typically used for DSL services.

Address Mode: Select Static if your ISP assigned you the IP address, subnet mask, gateway, and DNS server addresses. In most cases, select Dynamic.

L2TP IP Address: Enter the L2TP IP address supplied by your ISP (Static only).

L2TP Subnet Mask: Enter the Subnet Mask supplied by your ISP (Static only).

L2TP Gateway: Enter the Gateway IP Address provided by your ISP.

L2TP Server IP: Enter the Server IP provided by your ISP (optional).

Username: Enter your L2TP username.

Password: Enter your L2TP password and then retype the password in the next box.

Reconnect Mode: Select either Always-on,On-Demand, or Manual.

Maximum Idle Time: Enter a maximum idle time during which the Internet connection is maintained during inactivity. To disable this feature, enable Auto-reconnect.

DNS Servers: Enter the Primary and Secondary DNS Server Addresses (Static L2TP only).

D-Link DIR-625 User Manual

23

Image 23
Contents Page Table of Contents Warranty Registration Wireless SecurityProductPackageOverviewContents Total Performance IntroductionFeatures Connections Hardware OverviewInternet LED LEDsBefore you Begin InstallationWireless Installation Considerations Connect to Cable/DSL/Satellite Modem Connect to Another Router Installation Web-based Configuration Utility ConfigurationClick Launch Internet Connection Setup Wizard to begin Setup WizardConfiguration Configuration Configuration Dynamic Cable Manual ConfigurationPPPoE DSL Internet SetupPptp Page L2TP Page Static assigned by ISP Big Pond Wireless Settings Visibility Status Network Settings Dhcp Server Settings Dhcp Reservation Virtual Server Configuration Port Forwarding Application Rules Speed QoS EngineNetwork Filters Access Control Access Control Wizard Access Control Wizard Website Filters Inbound Filters Firewall Settings Application Level Gateway ALG Configuration Transmit Power Set the transmit power of the antennas Advanced Wireless SettingsAdvanced Network Settings Administrator Settings Time Settings SysLog Server SysLog Server SysLogAuthentication authentication Email SettingsSystem Settings Check Email Notification of Newer Firmware Update FirmwareDdns System Check Schedules Device Information Log Active Sessions StatsSupport WirelessWhat is WEP? Wireless SecurityWhat is WPA? Wireless Security Setup Wizard Security Security Configure WEP Configure WPA-Personal PSK Configure WPA-Enterprise Radius Security Using Windows XP Connect to a Wireless NetworkConfigure WEP Connecting to a Wireless Network Configure WPA-PSK Connecting to a Wireless Network Why can’t I access the web-based configuration utility? TroubleshootingWhat can I do if I forgot my password? Troubleshooting Troubleshooting Wireless Basics Wireless Local Area Network Wlan What is Wireless?Small Office and Home Office Wireless Personal Area Network WpanHome Eliminate Interference Centralize your router or Access PointSecurity Wireless ModesCheck your IP address Networking BasicsStep Highlight Internet Protocol TCP/IP and click Properties StepMSC Dimensions Technical SpecificationsPhone Support Contacting Technical SupportLimited Warranty WarrantyNon-Applicability of Warranty Limited Software WarrantyDisclaimer of Other Warranties What Is Not CoveredCopyright Statement Limitation of LiabilityGoverning Law TrademarksFCC Caution CE Mark WarningFCC Statement IC Radiation Exposure Statement IC statementRegistration