D-Link DIR-625 manual Dhcp Server Settings

Page 30

Section 3 - Configuration

DHCP Server Settings

DHCP stands for Dynamic Host Control Protocol. The DIR-625 has a built-in DHCP server. The DHCP Server will automatically assign an IP address to the computers on the LAN/private network. Be sure to set your computers to be DHCP clients by setting their TCP/IP settings to “Obtain an IP Address Automatically.” When you turn your computers on, they will automatically load the proper TCP/IP settings provided by the DIR-625.The DHCP Server will automatically allocate an unused IP address from the IP address pool to the requesting computer.You must specify the starting and ending address of the IP address pool.

Enable DHCP Check this box to enable the DHCP server on

Server: your router. Uncheck to disable this function.

DHCP IP Address Enter the starting and ending IP addresses for

Range: the DHCP server’s IP assignment.

Note: If you statically (manually) assign IP addresses to your computers or devices, make sure the IP addresses are outside of this range or you may have an IP conflict.

Lease Time: The length of time for the IP address lease.

Enter the Lease time in minutes.

Add DHCP Refer to the next page for the DHCP Reservation

Reservation: function.

D-Link DIR-625 User Manual

30

Image 30

Contents Page Table of Contents Wireless Security Warranty RegistrationProductPackageOverviewContents Introduction Total PerformanceFeatures Hardware Overview ConnectionsLEDs Internet LEDInstallation Before you BeginWireless Installation Considerations Connect to Cable/DSL/Satellite Modem Connect to Another Router Installation Configuration Web-based Configuration UtilitySetup Wizard Click Launch Internet Connection Setup Wizard to beginConfiguration Configuration Configuration Manual Configuration Dynamic CableInternet Setup PPPoE DSLPptp Page L2TP Page Static assigned by ISP Big Pond Wireless Settings Visibility Status Network Settings Dhcp Server Settings Dhcp Reservation Virtual Server Configuration Port Forwarding Application Rules QoS Engine SpeedNetwork Filters Access Control Access Control Wizard Access Control Wizard Website Filters Inbound Filters Firewall Settings Application Level Gateway ALG Configuration Advanced Wireless Settings Transmit Power Set the transmit power of the antennasAdvanced Network Settings Administrator Settings Time Settings SysLog SysLog Server SysLog ServerEmail Settings Authentication authenticationSystem Settings Update Firmware Check Email Notification of Newer FirmwareDdns System Check Schedules Device Information Log Stats Active SessionsWireless SupportWireless Security What is WEP?What is WPA? Wireless Security Setup Wizard Security Security Configure WEP Configure WPA-Personal PSK Configure WPA-Enterprise Radius Security Connect to a Wireless Network Using Windows XPConfigure WEP Connecting to a Wireless Network Configure WPA-PSK Connecting to a Wireless Network Troubleshooting Why can’t I access the web-based configuration utility?What can I do if I forgot my password? Troubleshooting Troubleshooting Wireless Basics What is Wireless? Wireless Local Area Network WlanWireless Personal Area Network Wpan HomeSmall Office and Home Office Centralize your router or Access Point Eliminate InterferenceWireless Modes SecurityNetworking Basics Check your IP addressStep Step Highlight Internet Protocol TCP/IP and click PropertiesTechnical Specifications MSC DimensionsContacting Technical Support Phone SupportWarranty Limited WarrantyLimited Software Warranty Non-Applicability of WarrantyWhat Is Not Covered Disclaimer of Other WarrantiesTrademarks Limitation of LiabilityGoverning Law Copyright StatementCE Mark Warning FCC StatementFCC Caution IC statement IC Radiation Exposure StatementRegistration