D-Link DIR-625 manual IC statement, IC Radiation Exposure Statement

Page 92

Appendix E - Warranty

IC statement

Operation is subject to the following two conditions:

1)This device may not cause interference and

2)This device must accept any interference, including interference that may cause undesired operation of the device.

This device has been designed to operate with an antenna having a maximum gain of 2 dBi. Antenna having a higher gain is strictly prohibited per regulations of Industry Canada. The required antenna impedance is 50 ohms.

IMPORTANT NOTE:

IC Radiation Exposure Statement:

This equipment complies with IC radiation exposure limits set forth for an uncontrolled environment. End users must follow the specific operating instructions for satisfying RF exposure compliance. This equipment should be installed and operated with minimum distance 20cm between the radiator & your body.

This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.

Règlement d’Industry Canada

Les conditions de fonctionnement sont sujettes à deux conditions:

1)Ce périphérique ne doit pas causer d’interférence et.

2)Ce périphérique doit accepter toute interférence, y compris les interférences pouvant perturber le bon fonctionnement de ce périphérique.

The Class [B] digital apparatus meets all requirements of the Canadian Interference-Causing Equipment Regulation.

Cet appareil numerique de la class [B] respecte toutes les exigences du Reglement sur le materiel brouilleur du Canada.

D-Link DIR-625 User Manual

92

Image 92
Contents Page Table of Contents Wireless Security Warranty RegistrationProductPackageOverviewContents Introduction Total PerformanceFeatures Hardware Overview ConnectionsLEDs Internet LEDInstallation Before you BeginWireless Installation Considerations Connect to Cable/DSL/Satellite Modem Connect to Another Router Installation Configuration Web-based Configuration UtilitySetup Wizard Click Launch Internet Connection Setup Wizard to beginConfiguration Configuration Configuration Manual Configuration Dynamic CableInternet Setup PPPoE DSLPptp Page L2TP Page Static assigned by ISP Big Pond Wireless Settings Visibility Status Network Settings Dhcp Server Settings Dhcp Reservation Virtual Server Configuration Port Forwarding Application Rules QoS Engine SpeedNetwork Filters Access Control Access Control Wizard Access Control Wizard Website Filters Inbound Filters Firewall Settings Application Level Gateway ALG Configuration Advanced Wireless Settings Transmit Power Set the transmit power of the antennasAdvanced Network Settings Administrator Settings Time Settings SysLog SysLog Server SysLog ServerEmail Settings Authentication authenticationSystem Settings Update Firmware Check Email Notification of Newer FirmwareDdns System Check Schedules Device Information Log Stats Active SessionsWireless SupportWireless Security What is WEP?What is WPA? Wireless Security Setup Wizard Security Security Configure WEP Configure WPA-Personal PSK Configure WPA-Enterprise Radius Security Connect to a Wireless Network Using Windows XPConfigure WEP Connecting to a Wireless Network Configure WPA-PSK Connecting to a Wireless Network Troubleshooting Why can’t I access the web-based configuration utility?What can I do if I forgot my password? Troubleshooting Troubleshooting Wireless Basics What is Wireless? Wireless Local Area Network WlanSmall Office and Home Office Wireless Personal Area Network WpanHome Centralize your router or Access Point Eliminate InterferenceWireless Modes SecurityNetworking Basics Check your IP addressStep Step Highlight Internet Protocol TCP/IP and click PropertiesTechnical Specifications MSC DimensionsContacting Technical Support Phone SupportWarranty Limited WarrantyLimited Software Warranty Non-Applicability of WarrantyWhat Is Not Covered Disclaimer of Other WarrantiesLimitation of Liability Governing LawTrademarks Copyright StatementFCC Caution CE Mark WarningFCC Statement IC statement IC Radiation Exposure StatementRegistration