D-Link DIR-625 manual Port Forwarding

Page 34

Section 3 - Configuration

Port Forwarding

This will allow you to open a single port or a range of ports.

Name: Enter a name for the rule or select an application from the drop-down menu. Select an application and click << to populate the fields.

IP Address: Enter the IP address of the computer on your local network that you want to allow the incoming service to. If your computer is receiving an IP address automatically from the router (DHCP), you computer will be listed in the “Computer Name” drop-down menu. Select your computer and click <<.

TCP/UDP: Enter the TCP and/or UDP port or ports that you want to open.You can enter a single port or a range of ports. Seperate ports with a common.

Example: 24,1009,3000-4000

Inbound Filter: Select Allow All (most common) or a created Inbound filter. You may create your own inbound filters in the Advanced > Inbound Filter page.

Schedule: The schedule of time when the Virtual Server Rule will be enabled.The schedule may be set to Always, which will allow the particular service to always be enabled.You can create your own times in the Tools

>Schedules section.

D-Link DIR-625 User Manual

34

Image 34
Contents Page Table of Contents Wireless Security Warranty RegistrationProductPackageOverviewContents Introduction Total PerformanceFeatures Hardware Overview ConnectionsLEDs Internet LEDInstallation Before you BeginWireless Installation Considerations Connect to Cable/DSL/Satellite Modem Connect to Another Router Installation Configuration Web-based Configuration UtilitySetup Wizard Click Launch Internet Connection Setup Wizard to beginConfiguration Configuration Configuration Manual Configuration Dynamic CableInternet Setup PPPoE DSLPptp Page L2TP Page Static assigned by ISP Big Pond Wireless Settings Visibility Status Network Settings Dhcp Server Settings Dhcp Reservation Virtual Server Configuration Port Forwarding Application Rules QoS Engine SpeedNetwork Filters Access Control Access Control Wizard Access Control Wizard Website Filters Inbound Filters Firewall Settings Application Level Gateway ALG Configuration Advanced Wireless Settings Transmit Power Set the transmit power of the antennasAdvanced Network Settings Administrator Settings Time Settings SysLog SysLog Server SysLog ServerEmail Settings Authentication authenticationSystem Settings Update Firmware Check Email Notification of Newer FirmwareDdns System Check Schedules Device Information Log Stats Active SessionsWireless SupportWireless Security What is WEP?What is WPA? Wireless Security Setup Wizard Security Security Configure WEP Configure WPA-Personal PSK Configure WPA-Enterprise Radius Security Connect to a Wireless Network Using Windows XPConfigure WEP Connecting to a Wireless Network Configure WPA-PSK Connecting to a Wireless Network Troubleshooting Why can’t I access the web-based configuration utility?What can I do if I forgot my password? Troubleshooting Troubleshooting Wireless Basics What is Wireless? Wireless Local Area Network WlanHome Wireless Personal Area Network WpanSmall Office and Home Office Centralize your router or Access Point Eliminate InterferenceWireless Modes SecurityNetworking Basics Check your IP addressStep Step Highlight Internet Protocol TCP/IP and click PropertiesTechnical Specifications MSC DimensionsContacting Technical Support Phone SupportWarranty Limited WarrantyLimited Software Warranty Non-Applicability of WarrantyWhat Is Not Covered Disclaimer of Other WarrantiesTrademarks Limitation of LiabilityGoverning Law Copyright StatementFCC Statement CE Mark WarningFCC Caution IC statement IC Radiation Exposure StatementRegistration