D-Link DI-724GU manual Status, Device Info

Page 65

Section 3 - Configuration

Status

Device Info

All of your Internet and network connection details are displayed on the Device Information page. This is primarily a recap of all the WAN, LAN, Wireless, and DHCP options that are set from the Home tab. The firmware version is also displayed here.

Note: Some browsers have limitations that make it impossible to update the WAN status display when the status changes. Some browsers require that you refresh the display to obtain updated status. Some browsers report an error condition when trying to obtain WAN status.

DHCP Connection: Clicking the DHCP Release button unassigns the router’s IP address. The router will not respond to IP messages from the WAN side until you click the DHCP Renew button or power-up the router again. Clicking the DHCP Renew button causes the router to request a new IP address from the ISP’s server.

PPPoE, PPTP, L2TP Depending on whether the WAN connection is currently Connection: established, you can click either the Connect button to attempt to establish the WAN connection or the Disconnect

button to break the WAN connection.

BigPond Depending on whether you are currently logged in to BigPond, Connection: you can click either the BigPond Login button to attempt to establish the WAN connection or the BigPond Logout button

to break the WAN connection.

LAN Computers: This area of the screen continually updates to show all DHCP enabled computers and devices connected to the LAN side of your router. The detection “range” is limited to the address range as configured in DHCP Server. Computers that have an address outside of this range will not show. If the DHCP Client (i.e. a computer configured to “Automatically obtain an

D-Link DI-724GU User Manual

65

Image 65
Contents Page Table of Contents Warranty Registration Troubleshooting Wireless Basics Networking BasicsSystem Requirements Package ContentsIntroduction Features Wlan LED Hardware OverviewAntennas Hardware Installation Network Overview Wireless Installation Considerations Configuration Home Page Screen Setup Wizard Dynamic IP Address Static IP Address PPPoE Pptp L2TP Big Pond Wireless Setup Click Restart Printer Wizard Configuration Configuration Wireless Page WAN Page MAC Address Subnet MaskPage IP Address Username Password Verify Password Service Name Page ISP Address Maximum Idle Time Primary DNS AddressL2TP MTU Big Pond Primary DNS Address Secondary DNS Address IP Address Enable RIPPage Dhcp Computer Name IP Address MAC Address Entry Dhcp Client Always BroadcastVirtual Server AdvancedApplications Open Port ForwardingStreamEngine Detected xDSL or Other Frame Relay Network IP Filters FiltersMAC Filters MAC Filters Parental Control Firewall DMZ Dtim Interval PerformanceAll Day 24hrs SchedulesStart Time End TimeTools AdministrationUser PortAutomatic TimeNTP Server IntervalStart/End System Ddns Miscellaneous Select Print Server Device Info StatusPage On Log Full On Schedule LogWhat to View Logging Levels Statistics Wireless Status Priority State Dir Active SessionsInternal Print Server Help Why can’t I get a wireless connection? TroubleshootingWhy does my wireless connection keep dropping? What do I do if I forgot my encryption key.? Resetting the DI-724GU to Factory Default Settings?Wireless Basics Wireless Local Area Network Wlan What is Wireless?Small Office and Home Office HomeSecurity Centralize your router or Access PointEliminate Interference Wireless Modes Check your IP Address Networking BasicsStep Highlight Internet Protocol TCP/IP and click Properties StepDevice Management Technical SpecificationsLink Technical Support over the Internet Contacting Technical SupportLink Technical Support over the Telephone Limited Warranty WarrantyNon-Applicability of Warranty Limited Software WarrantyDisclaimer of Other Warranties What Is Not CoveredGoverning Law Limitation of LiabilityTrademarks Copyright StatementFCC Statement CE Mark WarningRegistration