Linksys WAP300N
Number of Wireless
Wireless Network
3.To connect to a wireless network, select the network, then click Connect.
A screen opens that shows you the network name (SSID) and security mode of the selected wireless network. Depending on the security mode of the network, you may be asked to enter additional information (see the following table).
| Information |
| |
Security mode | Required | Description | |
|
|
| |
WPA/WPA2 |
| Enter the passphrase shared by this | |
Passphrase | device and your wireless router (or | ||
Personal | |||
| access point). | ||
|
| ||
|
|
| |
|
| Select a level of WEP encryption, 40 / | |
| Encryption | ||
|
| (26 hex digits). | |
|
|
| |
|
| Enter the WEP key of your network. | |
| Key 1 | Key 1 is the transmit key used by this | |
|
| device. | |
|
|
| |
WEP |
| The default is Auto, which allows | |
| either open system or shared | ||
|
| ||
|
| key authentication to be used. | |
| Authentication | Select Open to use open system | |
| authentication (a WEP key is not used | ||
|
| ||
|
| for authentication). Select Shared to | |
|
| use shared key authentication (a WEP | |
|
| key is used for authentication). | |
|
|
|
4.After you have entered all required information, click Connect to connect to the network.
Setting Up: Basics
How to use Wi-Fi Protected Setup
If your wireless router or access point supports
You can use two methods for
••Press the
••Enter the WAP300N’s
To manually configure your network, see “How to manually set up your WAP300N” on page 14).
How to connect to a router or access point using the
Use this method to connect your WAP300N to a router or access point by pressing buttons on the two devices.
To connect to your router or access point using the
1.Press the
2.Within two minutes, press the
13