Linksys WAP54GX manual Back Panel

Page 13

Wireless-G Access Point with SRX

The Back Panel

The Access Point's Ethernet network and power ports, as well as the Reset button, are located on the back panel.

Figure 3-2: Back Panel

Reset Button There are two ways to reset the Access Point's factory defaults. Either press the Reset button, for approximately ten seconds, or use the Administration - Factory Defaults screen of the Access Point's Web-based Utility.

Ethernet Port The Ethernet network port connects to an Ethernet network device, such as a switch or router.

Power Port The Power port connects to the Access Point’s power adapter.

IMPORTANT: Resetting the Access Point will erase all of your settings (including wireless security, IP address, and power output) and replace them with the factory defaults. Do not reset the Access Point if you want to retain these settings.

port: the connection point on a computer or networking device used for plugging in cables or adapters

Chapter 3: Getting to Know the Wireless-G Access Point with SRX

7

The Back Panel

Image 13

Contents 802 GHz .11g Wireless- G Copyright and Trademarks How to Use this User GuideTable of Contents Appendix B Wireless Security Appendix a TroubleshootingFrequently Asked Questions Back Panel Front PanelWireless Security Radius Screen Welcome IntroductionWhat’s in this User Guide? Wireless-G Access Point with SRX Network Topology Planning Your Wireless NetworkRoaming Network Layout Wireless Getting to Know the Wireless-G Access Point with SRXBack Panel Connections for Setup Connecting the Wireless-G Access Point withOverview Using the Setup Wizard Setting up the Wireless-G Access Point withConnect the Network Cable to the Router or Switch Screen Check the Access Point’s Status Screen Password Screen Basic Settings Screen Wireless Settings Screen Configuring the Access Point’s Wireless SettingsWEP 128-Bit WEP 64-BitWPA2 Personal WPA/WPA2 Personal WPA Personal14 WPA2 Mixed Mode Settings Screen WPA2 Mixed Mode16 Congratulations Screen Setup Configuring the Wireless-G Access Point with SRXNavigating the Utility Administration WirelessStatus Setup Network Setup Tab Accessing the UtilityNetwork Setup Setup Static IP Screen Basic Wireless Settings Wireless Basic Wireless Settings TabWireless Security Wireless Wireless Security TabWPA2-Mixed Radius Wireless MAC Filter Wireless Wireless MAC Filter TabAdvanced Wireless Wireless Advanced Wireless Settings TabWireless-G Access Point with SRX Management Administration Management TabLog Administration Log TabAdministration Firmware Upgrade Tab Administration Factory Defaults TabFirmware Upgrade AP’s Information Status Local Network TabLocal Network Wireless Network Status Wireless Network TabFrequently Asked Questions Appendix a TroubleshootingWhat Ieee 802.11g features are supported? What is the ISM band? Does the Access Point function as a firewall? Security Precautions Appendix B Wireless SecuritySecurity Threats Facing Wireless Networks Security Threats Facing Wireless Networks Wireless-G Access Point with SRX Appendix C Upgrading Firmware Shared Resources Appendix D Windows HelpNetwork Neighborhood/My Network Places Appendix E Glossary Wireless-G Access Point with SRX Wireless-G Access Point with SRX Wireless-G Access Point with SRX Wireless-G Access Point with SRX Enable/disable Appendix F SpecificationsModel StandardsStorage Humidity Operating HumidityLimited Warranty Appendix G Warranty InformationFCC Statement Appendix H Regulatory InformationWireless-G Access Point with SRX Wireless-G Access Point with SRX Wireless-G Access Point with SRX Wireless-G Access Point with SRX Dual-Band Wireless Access Point Appendix I Contact Information