Reference Manual for the Model CG814M Wireless Cable Modem Gateway
If you need Client for Microsoft Networks:
a.Click the Add button.
b.Select Client, and then click Add.
c.Select Microsoft.
d.Select Client for Microsoft Networks, and then click OK.
3.Restart your PC for the changes to take effect.
Enabling DHCP to Automatically Configure TCP/IP Settings
After the TCP/IP protocol components are installed, each PC must be assigned specific information about itself and resources that are available on its network. The simplest way to configure this information is to allow the PC to obtain the information from the internal DHCP server of the CG814M Gateway. To use DHCP with the recommended default addresses, follow these steps:
1.Connect all PCs to the gateway, then restart the gateway and allow it to boot.
2.On each attached PC, open the Network control panel (refer to the previous section) and select the Configuration tab.
3.From the components list, select
4.In the IP Address tab, select “Obtain an IP address automatically”.
5.Select the Gateway tab.
6.If any gateways are shown, remove them.
7.Click OK.
8.Restart the PC.
Repeat steps 2 through 8 for each PC on your network.
Selecting Windows’ Internet Access Method
1.On the Windows taskbar, click the Start button, point to Settings, and then click Control Panel.
2.
3.Select “I want to set up my Internet connection manually” or “I want to connect through a Local Area Network” and click Next.
4.Select “I want to connect through a Local Area Network” and click Next.
Preparing Your Network |