Appendix B: Cables
Ethernet Cable
Specifications
Cable Types and Specifications
Cable | Type | Max. Length | Connector |
| | | |
10BASE-T | Cat. 3, 4, 5 100-ohm UTP | 100 m (328 ft) | RJ-45 |
| | | |
100BASE-TX | Cat. 5 100-ohm UTP | 100 m (328 ft) | RJ-45 |
| | | |
Twisted-pair Cable
Caution: DO-NOT plug a phone jack connector into any RJ-45 port. Use only twisted-pair cables with RJ-45 connectors that conform with FCC standards.
For 10BASE-T/100BASE-TX connections, a twisted-pair cable must have two pairs of wires. Each wire pair is identified by two different colors. For example, one wire might be red and the other, red with white stripes. Also, an RJ-45 connector must be attached to both ends of the cable. All RJ-45 ports on the CheetahAccess™ Wireless Gateway, except for the WAN port, support automatic MDI/MDI-X configuration. This means that you can use straight-through cable to attach the LAN ports to any network device. However, when connecting the WAN port to a broadband modem, you will need to use either straight-through or crossover cable, depending on the port type used on the modem.
Figure B-1 illustrates how the pins on the RJ-45 connector are numbered. Be sure to hold the connectors in the same orientation when attaching the wires to the pins.
Figure B-1. RJ-45 Connector Pin Numbers