Abocom AR1000 manual Powering On the Adsl Router

Page 5

Step 4 Connect one end of RS-232 cable to any free COM port in your system; Connect the other end to “Console” port on the rear panel of the ADSL router.

Powering On the ADSL ROUTER

Step 1 Connect the power adapter to your ADSL ROUTER by plugging one end of the power supply into an appropriate electrical outlet and the other end into port labeled 5VDC on the rear panel of the device.

Note: To power off he ADSL ROUTER, just unplug the power supply cable from the ADSL ROUTER rear panel POWER connector.

Step 2 Once your ADSL ROUTER is powered up, check to make sure the Power LED is red and ON.

Step 3 If the Power LED is not lit, immediately turn off all power to the ADSL ROUTER.

- 4 -

Image 5
Contents Adsl Router Parts Names and functions LED IndicatorRear view of the Adsl Router Top View of Adsl Router LEDsConnectors on the rear panel Connectors on the Rear PanelOne PC Adsl Router direct connection Setting Up the Hardware EnvironmentConnecting All Cables to the Network Powering On the Adsl Router Check Router Protocol and select IP over ATM Router Mode/ IP over ATM RFC1577Bridge mode/RFC1483 bridge Check LLC Encapsulation or VC Based Route or VC Based Bridge