Abocom AR1000 manual Bridge mode/RFC1483 bridge

Page 7

(8)Click “OK” to go to “Select Config” menu. Or click “Save As File” to save the settings for future use. Then click “Next”.

(9)Click “Configure” button. The configure utility will automatically setup the router for you. Expect a minor delay for configuration.

Bridge mode/RFC1483 bridge

(1)Run the “router.exe” file saved in the configuration utility. (Go to Start ÆProgramÆ ADSL Router xx Configuration UtilityÆConfiguration Utility.)

(2)Select a PC COM port available on your computer used to connect to the ADSL Router’s “Console” port.

(3)Click “Next” button.

(4)Select Mode “Bridge” and select “RFC1483 Bridge”.

(5) Click “Properties” button.

- 6 -

Image 7
Contents Adsl Router Top View of Adsl Router LEDs LED IndicatorParts Names and functions Rear view of the Adsl RouterConnectors on the rear panel Connectors on the Rear PanelConnecting All Cables to the Network Setting Up the Hardware EnvironmentOne PC Adsl Router direct connection Powering On the Adsl Router Check Router Protocol and select IP over ATM Router Mode/ IP over ATM RFC1577Bridge mode/RFC1483 bridge Check LLC Encapsulation or VC Based Route or VC Based Bridge