Alto-Shaam 1020ESG, 1218ESG, 1010ESG, 714ESG i n s t a l l a t i o n, w a t e r drainage - Stacked

i n s t a l l a t i o n

w a t e r drainage - Stacked

A union is required. Install a 1-1/2-inch (38mm) diameter connection, drain line and clamp into place. The drain line must always be a positive gradient away from the Combitherm oven and not more than 12-inches (305mm) before an air gap.

NOTE: In the U.S.A., this equipment is to be installed to comply with the Basic Plumbing Code of the Building Officials and Code Administrators International, Inc. [BOCA], and the Food Service Sanitation Manual of the Food & Drug Administration [FDA].

To Drain

- Floor Sink -

Note: Failure to connect the drain correctly can result in poor performance and/or damage the oven

Stand Pipe,

1-1/2" NPT (38mm)

diameter

Drain

Connection

1-1/2" NPT (38mm)

Air Gap to be within

the first 12" (305mm)

of the oven drain

Manifold Pipe, a minimum of 2" NPT (51mm) diameter for the entire run of the

bottom combi oven

when manifolded to ensure adequate draining

Drain

Connection

1-1/2" NPT (38mm)

Air Gap to be within

the first 12" (305mm)

of the oven drain

Manifold Pipe,

a minimum of

2" NPT (51mm)

diameter

COMBITOUCH® ESG SERIES • GAS INSTALLATION MANUAL • MN-29246 • 24.