Alto-Shaam 1010ESG 1020ESG, DIMENSIONS H x W x D, Water Requirements, Clearance Requirements

10•20ESG

5-7/8" (148mm)

26-9/16" (675mm) 19-11/16" (500mm) 17-1/4" (438mm)

A = UNTREATED WATER B = TREATED WATER C = ELECTRICAL

D = GAS

[D] 4-9/16" (116mm)		19-15/16"
[A,B] 4-3/8"	(110mm)
[C] 3-9/16"		(506mm)	49-13/16" (1265mm)
		Water Drain
(89mm)
		(Side Back)	47-7/8" (1215mm)
C
Steam Vent
A	(Top)
B		(1875mm)13/16"-
D
[D] 4-5/8" (116mm)		73
			31-3/4"

2" (50mm)	(805mm)
	44" (1118mm)
55-7/16"
(1407mm)

8-15/16" (226mm) 40-5/8"
	(1032mm) 9/16"(1258mm)	54-1/8" (1374mm)	7-7/8" (200mm)
	49-

2" 2-3/16"

(50mm) (56mm)

45-3/16"

(1148mm)

42-7/16"

(1077mm)

12-13/16" 22-11/16"

(325mm) (575mm)

Water Drain

(Bottom)

30-5/8" (778mm)

32-13/16"

(833mm)

DIMENSIONS: H x W x D

EXTERIOR:

54-1/8" x 49-13/16" x 45-3/16" (1374mm x 1265mm x 1148mm)

EXTERIOR WITH RECESSED DOOR:

54-1/8" x 53-13/16" x 45-3/16" (1374mm x 1366mm x 1148mm)

INTERIOR:

33-7/8" x 25-1/4" x 33-7/8" (860mm x 640mm x 860mm)

WATER REQUIREMENTS

WATER QUALITY MINIMUM STANDARDS

TWO (2) COLD WATER INLETS - DRINKING QUALITY

USING A WATER SUPPLY NOT MEETING ALTO-SHAAM’S MINIMUM

ONE (1) TREATED WATER INLET:

3/4" NPT*

* Can manifold off of

WATER QUALITY STANDARDS WILL VOID THIS WARRANTY.

ONE (1) UNTREATED WATER INLET: 3/4" NPT*

one 3/4" line.

It is the responsibility of the purchaser to ensure that incoming water supply is

LINE PRESSURE:

30 to 90 psi

2.8 to 6.2 bar

compliant with the specifications listed through adequate treatment measures.

WATER DRAIN: 1-1/2"connection WitH a 2" MiniMuM air Gap installed as close

Installation of the CombiGuardTM Water Filtration System is recommended, but

this system may not address all water quality issues present.

to tHe oven as possiBle. Materials Must WitHstand teMperatures up to 200°f (93°c).

CLEARANCE REQUIREMENTS

Contaminant

Inlet Water Requirements (untreated water)

LEFT 6" (152mm) RECOMMENDED SERVICE ACCESS: 18" (457mm)

Free Chlorine

Less than 0.1 ppm (mg/L)

Hardness

Less than 3 gpg (52 ppm)

20" (508mm) FROM HEAT PRODUCING EQUIPMENT

Chloride

Less than 30 ppm (mg/L)

RIGHT

4" (102mm)

TOP: 20" (508mm) FOR AIR MOVEMENT

pH

7.0 to 8.5

Alkalinity

Less than 50 ppm (mg/L)

BACK

4" (102mm)

BOTTOM: 5-1/8" (130mm) FOR LEGS

Silica

Less than 12 ppm (mg/L)

Total Dissolved Solids (tds)

Less than 60 ppm

GAS REQUIREMENTS (TYPE MUST BE SPECIFIED ON ORDER)

INSTALLATION REQUIREMENTS

CONNECTED ENERGY LOAD:

91,000 Btu / hr (Natural Gas)

• Oven must be installed level.

88,000 Btu / hr (Propane)

• Hood installation is required.

HOOK-UP:

3/4" NPT

• Water supply shut-off valve and back-flow preventer when

MINIMUM CONNECTED PRESSURE:

5.5" W.C. (Natural Gas)

required by local code.

9"

W.C. (Propane)

• Alternate burner orifice is required for installation sites at

MAXIMUM CONNECTED PRESSURE: 14" W.C.

elevations of 2,000 feet (610m) above sea level.

ELECTRICAL (DEDICATED CIRCUIT REQUIRED)

CombiSmoker®

MODEL

VOLTAGE

PH

HZ

AMPS

kW

AWG

CORD & PLUG

Additional kW

10•20ESG Touch

120

1

60

5.0

.58

AWG 12

NEMA L5-20P, 20A, 125V Plug

+ .7 kw

208 – 240

1

60

5.0

1.04

AWG 12

no cord or plug

+ .7 kw

208 – 240

3

60

5.0/ph

1.04

AWG 12

no cord or plug

+ .7 kw

10•20ESG

120

1

60

6.0

.69

AWG 12

NEMA L5-20P, 20A, 125V Plug

+ .7 kw

208 – 240

3

60

3.2/ph

1.14

AWG 12

no cord or plug

+ .7 kw

WEIGHT

CAPACITY

NET

573 lb est

(260 kg)

FULL-SIZE PANS:

20" x 12" x 2-1/2"

Twenty (20)

SHIP

875 lb

(397 kg)

GN 1/1:

530 x 325 x 65mm

Twenty (20)

CRATE DIMENSIONS: (L x W x H)

GN 2/1:

650 x 530 x 65mm

Ten (10)

45" x 53" x 59"

FULL-SIZE SHEET PANS:*

18" x 26" x 1"

Ten (10)

(1143 x 1346 x 1499mm)

ON WIRE SHELVES ONLY

240 lb (109 kg) MAXIMUM

VOLUME MAXIMUM: 150 quarts (190 liters)

*ADDITIONAL WIRE SHELVES REQUIRED FOR MAXIMUM CAPACITY

COMBITOUCH® ESG SERIES • GAS INSTALLATION MANUAL • MN-29246 • 11.