Abocom AR1000 Router Mode/ IP over ATM RFC1577, Check Router Protocol and select IP over ATM

Page 6

INTERNET ACCESS

Router Mode/ IP over ATM (RFC1577)

(1)Run the “router.exe” file saved in the configuration utility. (Go to Start ÆProgramÆ ADSL Router xx Configuration UtilityÆConfiguration Utility.)

(2)Select a PC COM port available on your computer used to connect to the ADSL Router’s “Console” port.

(3)Check “Router Protocol” and select “IP over ATM”.

(4)Click “Properties” button.

(5)Enter “ADSL IP”, “Gateway IP”, and “Subnet Mask” addresses provided by your service provider.

(6)Usually Ethernet IP addresses were not provided by service providers. Check to make sure if this is your case, if yes, remember to select “Enable NAT function.”

(7)Enter the VPI and VCI numbers. Typically VPI is set to “0”.

- 5 -

Image 6
Contents Adsl Router Rear view of the Adsl Router LED IndicatorParts Names and functions Top View of Adsl Router LEDsConnectors on the Rear Panel Connectors on the rear panelSetting Up the Hardware Environment Connecting All Cables to the NetworkOne PC Adsl Router direct connection Powering On the Adsl Router Router Mode/ IP over ATM RFC1577 Check Router Protocol and select IP over ATMBridge mode/RFC1483 bridge Check LLC Encapsulation or VC Based Route or VC Based Bridge