Abocom AR1000 manual Setting Up the Hardware Environment, Connecting All Cables to the Network

Page 4

Setting Up the Hardware Environment

Connecting All Cables to the Network

Perform the following procedures to set up the ADSL ROUTER.

Step 1 Connect the power adapter to the port labeled 5VDC on the rear panel of this device.

Step 2 Connect the Ethernet cable.

One PC – ADSL Router (direct connection)

If your only have one PC, you can connect your ADSL ROUTER to the PC directly without a hub. For a single Ethernet-equipped PC, use the "non-hub" twisted-pair crossover cable to connect the ADSL ROUTER Ethernet port to the Ethernet port on your computer.

Home Network – ADSL Router (connection through Ethernet Switch/Hub)

If your ADSL ROUTER is connected to a home network, you may use a standard Ethernet cable (not provided) to connect your ADSL ROUTER Ethernet port to an available port on your home network Ethernet hub.

Step 3 Connect the ADSL cable to the ADSL ROUTER. Connect the ADSL ROUTER to the ADSL line with the provided telephone cable.

- 3 -

Page 3 Page 5
Image 4
Page 3 Page 5
Contents Adsl Router LED Indicator Parts Names and functionsRear view of the Adsl Router Top View of Adsl Router LEDsConnectors on the Rear Panel Connectors on the rear panelConnecting All Cables to the Network Setting Up the Hardware EnvironmentOne PC Adsl Router direct connection Powering On the Adsl Router Router Mode/ IP over ATM RFC1577 Check Router Protocol and select IP over ATMBridge mode/RFC1483 bridge Check LLC Encapsulation or VC Based Route or VC Based Bridge
Top Page Image Contents