INSTALLATION INSTRUCTIONS
BEFORE YOU BEGIN
Read these instructions completely and carefully.
Save these instructions for local inspector’s use.
IMPORTANT–OBSERVE ALL GOVERNING CODES AND ORDINANCES.
NOTE TO INSTALLER: Be sure to leave these instructions with the consumer.
FOR YOUR SAFETY
If YOU SMELL GAS:
1.Open windows.
2.Don’t touch any electrical switches.
3.Extinguish any open flame.
4.Immediately call your gas supplier. for your safety
Do not store or use gasoline or other flammable vapors and liquids in the vicinity of this or any other appliance.
PARTS LIST
Cooktop
•4 burner grates
•4 burner caps
•Gas pressure regulator with attached 1/2″ to 3/8″ reducing bushing and 3/8″ pipe nipple
•2 clamping brackets with screws
•Attached 120 volt grounded plug cord
•Self adhesive gasket 1/4″ x 36″ (1) 3/16″ x 36″ (2)
Downdraft Unit
•Downdraft unit
•Downdraft stability brackets
•Two filters
Blower Unit
JXBA55 motor and blower assembly is required for both models.
JXBC55 optional outdoor cover accessory may be ordered for installation of blower and motor assembly on the outside wall.
•Blower
•Nuts and washers
TOOLS AND PARTS NEEDED
•Large flat blade screwdriver
•Saw
•Carpenter’s square
•Pipe wrench
•Manual gas line
•Pipe joint sealant that resists action of LP gas
•Ductwork to suit the installation.
For flexible connection where local codes permit:
•Flexible metal tubing (same 3/4″ or 1/2″ I.D. as gas supply line)
•Flare union adapter for connection to supply line (3/4″ NPT x 3/4″ I.D. or 1/2″ NPT x 1/2″ I.D.)
•Flare union adapter for connection to regulator (1/2″ NPT x 3/4″ I.D. or 1/2″ I.D.)
For rigid connection:
• Pipe fittings as required
(continued next page)
13