STEP 9
Assemble Burners, Check Ignition
Assemble burner as shown.
Top grate
Burner cap
Check for proper ignition:
•Push in one control knob and turn 90° to HIGH position.
•The igniter will spark and the burner will light; the igniter will cease sparking when the burner is lit.
•First test may require some time, while air is flushed out of the gas line.
•Turn knob to OFF.
•Repeat the procedure for each burner.
STEP 10
Install Filters, Check Operation of Downdraft
To raise the vent, turn the VENT knob to
RAISE/LOWER.
•Hold the knob until the vent begins to raise. The vent will automatically stop when it is fully extended.
•Tip filter into the opening and pull straight down so that the filter rests on slides.
• Slide the filter to the right side.
•Tip the other filter into the opening and pull straight down.
•To turn the fan on, turn the FAN knob to HIGH. Continue turning the FAN knob to select a fan speed between HIGH and LOW.
NOTE: It is not necessary to turn the fan OFF before lowering the vent. The fan will automatically turn off when the vent is lowered. When the fan is not turned off before lowering the vent, it will automatically come on at the previously selected speed when the vent is fully raised.
To lower the vent, turn the VENT knob to RAISE/LOWER. Hold the knob until the vent begins to lower.
23
