INSTALLATION INSTRUCTIONS
(continued)
STEP 6
Install the Cooktop (continued)
1/16″
3/8″
• Cut a 3/16″ gasket strip in half. Peel off the |
backing and apply to the underside of the glass |
cooktop edge, on each side at least 3/8″ from |
STEP 7
Electrical Connections
•Connect the
•Slide the metal cover over the connection and secure with screws.
the back and as close to the edge as possible |
without protruding. |
• Apply the other gasket strip to the underside |
of the glass at the front of the cooktop. |
• Remove remaining adhesive backing. |
• Position the cooktop over the opening, making |
sure that the power cord is dropped into the |
cabinet. |
• Lower the cooktop into the cutout, pressing |
gently and evenly to seat. |
Service plate
Electrical supply cord
Metal cover
Electrical
Pressure regulator
NOTE: If the cooktop is installed in a 36″ base cabinet, the mounting brackets cannot be used because of interference with the cabinet sides. In this case, the cooktop can be secured to the cabinet with angle brackets (not supplied).
• Connect the |
downdraft assembly to the |
on the underside of the cooktop, next to the |
power cord. |
• Slide the metal cover over the connection and |
Remove one screw at the bottom of the cooktop body on both sides and secure the bracket with those screws. Then, secure the brackets to the cabinet sides.
•Insert
Gasket
Countertop |
secure with screws. |
STEP 8
Connect Power
Plug power cord into properly grounded receptacle.
Cooktop has three slots, the highest available will depend on the thickness of the countertop.
•Secure the brackets to the underside of the countertop with screws provided.
22