Actiontec electronic WNS100-250, WNS100-200, WNS100-160, WNS100-400, WNS100-300 manual

Page 57

Actiontec Wireless Network Attached Storage Device User Manual

Problem 2: The NAS Device is configured, but I can’t find it in Network Neighborhood.

Solution 2 Try using Start - Find - Computer, and enter the NAS Device's name. If this does not work, use Control Panel - Network to check the following:

•TCP/IP protocol is installed. If not, use Add - Protocol - Microsoft - TCP/IP to install it.

•Check the network Bindings:

•Ensure the TCP/IP protocol is bound to the Network card (NIC).

Select the Network card, click Properties, and then the Bindings tab. If TCP/IP is not bound (checked), check it.

•Ensure the TCP/IP -> Network card entry is bound to the Client for Microsoft Networks service.

Select the TCP/IP entry for the Network Card, click Properties, and then the Bindings tab. If Client for Microsoft Networks is not bound (checked), check it.

•If you don't have a router, check that the IP address is compatible with the NAS Device's. This means it needs to be from the same address range (e.g. 192.168.0.1 to 192.168.0.254) and using the same subnet mask (e.g. 255.255.255.0)

•If you do have a router, check that the gateway IP address is set correctly. Ask the administrator for the correct value.

54

Image 57

Contents Storage Device Table of Contents This page left intentionally blank Introduction1 FeaturesPackage Contents System RequirementsTechnical Support Client PC Setup Configuring NAS DeviceRight-click on the desired share on the Device From the menu that appears, select Map Network Drive… Tips for Storing Data on the NAS Device Accessing the NAS DeviceConfiguring the NAS Device FLASH/USB HDD Changing the PasswordConfiguring the NAS Device Adding a Print Server USB DevicesConfiguring the NAS Device Page Configuring the NAS Device Page Other Configurations This page left intentionally blank Accessing the Administrative Utility Using Administrative UtilityUsers Using the Administrative Utility Page System Status Page Network Settings Wireless SettingsObtain IP Address Automatically Dhcp Client IP AddressGateway Router Network MaskSystem Settings Workgroup View Log Page Advanced Setup New Group AccessExisting Groups CreateTo Add Access Rights Accessible Share FoldersTo Remove Access Rights Group NameMembers Users HelpOther Users To Add a Member to the GroupShared Folders To Delete a Member from the GroupBrowse Access RightsDo Not Share NameGroups with Access SaveShare Name When finished, click Close Backup Config BackupOther Groups Click here to run the selected backup job immediately Backup NowClick here to delete the selected backup job ModifyBackup Type This text box displays a log of completed backup jobsView Log Add New JobDirection Access the Folder Requires LoginShare Other DevicePrepare Disk Scandisk Self-test S.M.A.R.TStandby CancelDisk Log Use this to view the results of the last Scandisk operationUpgrade Start UpgradeCurrent Firmware This page left intentionally blank Accessing the Wireless Settings Configuring Wireless SettingsSetting Up Wireless Operation Configuring the Wireless Settings Setting Up Wireless SecurityAuthentication Type WEP EncryptionBit WEP key is WPA Pre-Shared Key WPA Group Rekey IntervalWPA Encryption This page left intentionally blank Connecting Via the Internet Accessing the NAS Device on the InternetUsing the Web Browser from the Internet Remote ManagementFTP File Transfer Protocol Troubleshooting Page Troubleshooting Solution 3 This can happen in the following situationsThis page left intentionally blank Power Input 12VDC 1A Linear Specifications aRelative Humidity 80% non-condensing Limited Warranty Year Regulatory Compliance Notices ModificationsClass B Equipment All other names are the property of their respective owners Miscellaneous Legal NoticesLimited Warranty Actiontec Electronics, Inc North Mary Avenue Sunnyvale, CA Limited Warranty