Airlink RT210W user manual Physical Outlook, Front Panel, LED Indicator

Page 15

2 Hardware Description & Installation

2.1 Physical Outlook

Front Panel

The following illustration shows the front panel of the Wireless Broadband Router:

Figure 2-1 LED Indicator

LED Indicator

The Wireless Broadband Router is equipped with seven LEDs on the front panel as described in the table below (from left to right):

LEDs

Color

Status

Description

PWR

Green

Off

No power is supplied to the unit.

 

 

Solid

Power is connected to the unit.

 

 

 

 

 

 

 

 

Off

WLAN interface is not initialized

 

 

properly.

 

 

 

 

 

 

 

WLAN

Green

On

WLAN interface is initialized properly

and ready.

 

 

 

 

 

 

 

 

 

Blinking

Transmitting/receiving packets

 

 

wirelessly.

 

 

 

 

 

 

 

LAN 1-4

Green/Amber

Off

No Ethernet device is connected.

 

 

 

 

5

Image 15
Contents Page Trademarks DisclaimerSafety Instructions For Service FCC Information Page Contents Appendix a Troubleshooting SpecificationList of Figures Page Overview Introduction∙ NAT FeaturesSystem Requirements Package ContentsPage LED Indicator Physical OutlookFront Panel Rear Panel and Connector Rear Panel and ConnectorHardware Connection Choosing a Place for the Wireless Broadband RouterConnecting the power adapter Connecting the Wireless Broadband RouterConnecting wired device to the LAN port Connecting Cable/ADSL Modem to the WAN portFigure below illustrates a connection diagram example Page Configuring Local Computer to Access the Wireless Router Control Panel Setting up TCP/IPOption a Using Dhcp For Windows 98/MEOption B Using Fixed IP Address ∙ On the IP Address tab, select Specify an IP address192.168.1.1 Check/Renew IP Address under Windows 98/ME For Windows 2000/XPSelect Use the following IP address and enter these ∙ Default GatewayAdditional Settings for Wireless Client ∙ Authentication OpenCheck/Renew IP Address under Windows 2000/XP For example C\ping Checking Connection with the Wireless Broadband RouterRequest time out Destination host unreachable Accessing Web-Based Configuration Utility Web ConfigurationApplying Changes Making the Changes EffectiveGeneral Information System Overview Router ModeSystem Overview Bridge Mode Part 1 Configuring general settings WAN Configuration Router ModePart 2. Configuring protocol-specific settings Dhcp ClientPPPoE Client WAN Configuration PPPoE Client Manual Config WAN Configuration Bridge ModeEnabling Bridging Mode Dhcp Server Router Mode Only LAN ConfigurationLAN Configuration Router Mode LAN Spanning Tree Protocol Router Mode Only11 Dhcp Lease Table Viewing Current Dhcp Assignments Router Mode OnlyBasic Configuration Wireless LAN 2.4G Configuration12 Access Point Mode Wireless Bridge13 Wireless Bridge Mode Advanced Configuration Access ControlPage Network Authentication Wireless LAN SecurityFormat Minimum Characters WEPNetwork Key fields 64 Bit Hexadecimal digits Ascii characters 128 Bit Key Length HEX Format Ascii Format15 Wireless LAN Security Filters Router Mode Only GeneralConnection Logging LAN Client Filter LAN MAC Filter16 Filters Forwarding Router Mode OnlyApplication Specific Port Forwards DMZ IP AddressPort Forwards DescriptionStatic Routes System Clock AdministrationFirmware Upgrade Management SetupRestore Factory Defaults Current Firmware version fieldSystem Page Troubleshooting Page Physical Power Adapter and Environmental RequirementHardware InterfaceSoftware WAN Port FeaturesLAN Port Features Router FeaturesSecurity Features Wireless LAN FeaturesConfiguration and Management Features Technical Support