Airlink RT210W user manual WAN Configuration Bridge Mode, Manual Config

Page 36

Wireless Broadband Router User Manual

uManual Config

If Manual Config is your option, configure these fields as required by your ISP.

IP Address/Subnet Mask/Default Gateway: Enter the IP address, subnet mask, and default gateway given by the ISP in respective fields.

DNS Servers: Specifies the IP address of the Domain Name Server. Your LAN side DHCP clients use the DNS to map a domain name to its corresponding IP address and vice versa. Up to three DNS servers are allowed. If no DNS server is specified or the specified servers are not available, the router will automatically assign a DNS server to the DHCP clients.

WINS Servers: Optional for Windows Internet Name Service. Enter the IP addresses of WINS servers if required.

Domain Name: Optional. Enter the domain name for the router.

After you finish the WAN settings, click Apply to enable the changes.

Figure 4-7 WAN Configuration – Manual Config

4.4 WAN Configuration – Bridge Mode

A bridge connects two or more LANs together and bases the forwarding decision on the MAC address. Under Bridge mode, filters

26

Image 36

Contents Page Disclaimer TrademarksSafety Instructions For Service FCC Information Page Contents Troubleshooting Specification Appendix aList of Figures Page Introduction OverviewFeatures ∙ NATPackage Contents System RequirementsPage LED Indicator Physical OutlookFront Panel Rear Panel and Connector Rear Panel and ConnectorChoosing a Place for the Wireless Broadband Router Hardware ConnectionConnecting the Wireless Broadband Router Connecting wired device to the LAN portConnecting Cable/ADSL Modem to the WAN port Connecting the power adapterFigure below illustrates a connection diagram example Page Configuring Local Computer to Access the Wireless Router Setting up TCP/IP Option a Using DhcpFor Windows 98/ME Control PanelOption B Using Fixed IP Address ∙ On the IP Address tab, select Specify an IP address192.168.1.1 For Windows 2000/XP Check/Renew IP Address under Windows 98/ME∙ Default Gateway Select Use the following IP address and enter theseAdditional Settings for Wireless Client ∙ Authentication OpenCheck/Renew IP Address under Windows 2000/XP Checking Connection with the Wireless Broadband Router For example C\pingRequest time out Destination host unreachable Web Configuration Accessing Web-Based Configuration UtilityMaking the Changes Effective Applying ChangesSystem Overview Router Mode General InformationSystem Overview Bridge Mode WAN Configuration Router Mode Part 1 Configuring general settingsPart 2. Configuring protocol-specific settings Dhcp ClientPPPoE Client WAN Configuration PPPoE Client WAN Configuration Bridge Mode Manual ConfigEnabling Bridging Mode LAN Configuration Dhcp Server Router Mode OnlyLAN Spanning Tree Protocol Router Mode Only LAN Configuration Router ModeViewing Current Dhcp Assignments Router Mode Only 11 Dhcp Lease TableWireless LAN 2.4G Configuration Basic ConfigurationWireless Bridge 12 Access Point Mode13 Wireless Bridge Mode Access Control Advanced ConfigurationPage Wireless LAN Security Network AuthenticationFormat Minimum Characters WEPNetwork Key fields Key Length HEX Format Ascii Format 64 Bit Hexadecimal digits Ascii characters 128 Bit15 Wireless LAN Security Filters Router Mode Only GeneralConnection Logging LAN MAC Filter LAN Client FilterForwarding Router Mode Only 16 FiltersDMZ IP Address Port ForwardsDescription Application Specific Port ForwardsStatic Routes Administration System ClockManagement Setup Firmware UpgradeRestore Factory Defaults Current Firmware version fieldSystem Page Troubleshooting Page Power Adapter and Environmental Requirement HardwareInterface PhysicalWAN Port Features LAN Port FeaturesRouter Features SoftwareSecurity Features Wireless LAN FeaturesConfiguration and Management Features Technical Support