Airlink RT210W user manual FCC Information

Page 5

FCC Information

FCC Statement

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communication. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.

Increase the separation between the equipment and receiver.

Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

Consult the dealer or an experienced radio/TV technician for help.

FCC conditions

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:

1.This device may not cause harmful interference.

2.This device must accept any interference received, including interference that may cause undesired operation.

FCC Radiation Exposure Statement

This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with a minimum distance of 20cm between the radiator & your body.

iii

Image 5
Contents Page Trademarks DisclaimerSafety Instructions For Service FCC Information Page Contents Appendix a Troubleshooting SpecificationList of Figures Page Overview Introduction∙ NAT FeaturesSystem Requirements Package ContentsPage Front Panel LED IndicatorPhysical Outlook Rear Panel and Connector Rear Panel and ConnectorHardware Connection Choosing a Place for the Wireless Broadband RouterConnecting wired device to the LAN port Connecting the Wireless Broadband RouterConnecting Cable/ADSL Modem to the WAN port Connecting the power adapterFigure below illustrates a connection diagram example Page Configuring Local Computer to Access the Wireless Router Option a Using Dhcp Setting up TCP/IPFor Windows 98/ME Control Panel192.168.1.1 Option B Using Fixed IP Address∙ On the IP Address tab, select Specify an IP address Check/Renew IP Address under Windows 98/ME For Windows 2000/XPSelect Use the following IP address and enter these ∙ Default GatewayCheck/Renew IP Address under Windows 2000/XP Additional Settings for Wireless Client∙ Authentication Open For example C\ping Checking Connection with the Wireless Broadband RouterRequest time out Destination host unreachable Accessing Web-Based Configuration Utility Web ConfigurationApplying Changes Making the Changes EffectiveGeneral Information System Overview Router ModeSystem Overview Bridge Mode Part 1 Configuring general settings WAN Configuration Router ModePPPoE Client Part 2. Configuring protocol-specific settingsDhcp Client WAN Configuration PPPoE Client Manual Config WAN Configuration Bridge ModeEnabling Bridging Mode Dhcp Server Router Mode Only LAN ConfigurationLAN Configuration Router Mode LAN Spanning Tree Protocol Router Mode Only11 Dhcp Lease Table Viewing Current Dhcp Assignments Router Mode OnlyBasic Configuration Wireless LAN 2.4G Configuration12 Access Point Mode Wireless Bridge13 Wireless Bridge Mode Advanced Configuration Access ControlPage Network Authentication Wireless LAN SecurityNetwork Key fields Format Minimum CharactersWEP 64 Bit Hexadecimal digits Ascii characters 128 Bit Key Length HEX Format Ascii Format15 Wireless LAN Security Connection Logging Filters Router Mode OnlyGeneral LAN Client Filter LAN MAC Filter16 Filters Forwarding Router Mode OnlyPort Forwards DMZ IP AddressDescription Application Specific Port ForwardsStatic Routes System Clock AdministrationFirmware Upgrade Management SetupSystem Restore Factory DefaultsCurrent Firmware version field Page Troubleshooting Page Hardware Power Adapter and Environmental RequirementInterface PhysicalLAN Port Features WAN Port FeaturesRouter Features SoftwareConfiguration and Management Features Security FeaturesWireless LAN Features Technical Support