Airlink RT210W user manual For Service

Page 4

For Service

Do not attempt to disassemble or open the cover of this unit yourself. You should not attempt to service the product yourself, which may void the user’ s authority to operate it. Contact qualified service personnel under the following conditions:

If the power cord or plug is damaged or frayed.

If liquid has been spilled into the product.

If the product has been exposed to rain or water.

If the product does not operate normally when the operating instructions are followed.

If the product has been dropped or the case has been damaged.

If the product exhibits a distinct change in performance.

ii

Image 4
Contents Page Disclaimer TrademarksSafety Instructions For Service FCC Information Page Contents Troubleshooting Specification Appendix aList of Figures Page Introduction OverviewFeatures ∙ NATPackage Contents System RequirementsPage Physical Outlook LED IndicatorFront Panel Rear Panel and Connector Rear Panel and ConnectorChoosing a Place for the Wireless Broadband Router Hardware ConnectionConnecting the Wireless Broadband Router Connecting wired device to the LAN portConnecting Cable/ADSL Modem to the WAN port Connecting the power adapterFigure below illustrates a connection diagram example Page Configuring Local Computer to Access the Wireless Router Setting up TCP/IP Option a Using DhcpFor Windows 98/ME Control Panel∙ On the IP Address tab, select Specify an IP address Option B Using Fixed IP Address192.168.1.1 For Windows 2000/XP Check/Renew IP Address under Windows 98/ME∙ Default Gateway Select Use the following IP address and enter these∙ Authentication Open Additional Settings for Wireless ClientCheck/Renew IP Address under Windows 2000/XP Checking Connection with the Wireless Broadband Router For example C\pingRequest time out Destination host unreachable Web Configuration Accessing Web-Based Configuration UtilityMaking the Changes Effective Applying ChangesSystem Overview Router Mode General InformationSystem Overview Bridge Mode WAN Configuration Router Mode Part 1 Configuring general settingsDhcp Client Part 2. Configuring protocol-specific settingsPPPoE Client WAN Configuration PPPoE Client WAN Configuration Bridge Mode Manual ConfigEnabling Bridging Mode LAN Configuration Dhcp Server Router Mode OnlyLAN Spanning Tree Protocol Router Mode Only LAN Configuration Router ModeViewing Current Dhcp Assignments Router Mode Only 11 Dhcp Lease TableWireless LAN 2.4G Configuration Basic ConfigurationWireless Bridge 12 Access Point Mode13 Wireless Bridge Mode Access Control Advanced ConfigurationPage Wireless LAN Security Network AuthenticationWEP Format Minimum CharactersNetwork Key fields Key Length HEX Format Ascii Format 64 Bit Hexadecimal digits Ascii characters 128 Bit15 Wireless LAN Security General Filters Router Mode OnlyConnection Logging LAN MAC Filter LAN Client FilterForwarding Router Mode Only 16 FiltersDMZ IP Address Port ForwardsDescription Application Specific Port ForwardsStatic Routes Administration System ClockManagement Setup Firmware UpgradeCurrent Firmware version field Restore Factory DefaultsSystem Page Troubleshooting Page Power Adapter and Environmental Requirement HardwareInterface PhysicalWAN Port Features LAN Port FeaturesRouter Features SoftwareWireless LAN Features Security FeaturesConfiguration and Management Features Technical Support