Airlink RT210W user manual Wireless LAN Security, Network Authentication

Page 46

Wireless Broadband Router User Manual

wireless clients to share the network. In other words, it improves

wireless network efficiency and boosts throughput.

Figure 4-14 Wireless LAN (2.4 GHz)

4.7 Wireless LAN Security

This page configures the wireless security mode.

uNetwork Authentication

Network Authentication: Disabled by default. If the local network has an authentication server such as Radius server, the user can

36

Image 46

Contents Page Disclaimer TrademarksSafety Instructions For Service FCC Information Page Contents Troubleshooting Specification Appendix aList of Figures Page Introduction OverviewFeatures ∙ NATPackage Contents System RequirementsPage Physical Outlook LED IndicatorFront Panel Rear Panel and Connector Rear Panel and ConnectorChoosing a Place for the Wireless Broadband Router Hardware ConnectionConnecting Cable/ADSL Modem to the WAN port Connecting the Wireless Broadband RouterConnecting wired device to the LAN port Connecting the power adapterFigure below illustrates a connection diagram example Page Configuring Local Computer to Access the Wireless Router For Windows 98/ME Setting up TCP/IPOption a Using Dhcp Control Panel∙ On the IP Address tab, select Specify an IP address Option B Using Fixed IP Address192.168.1.1 For Windows 2000/XP Check/Renew IP Address under Windows 98/ME∙ Default Gateway Select Use the following IP address and enter these∙ Authentication Open Additional Settings for Wireless ClientCheck/Renew IP Address under Windows 2000/XP Checking Connection with the Wireless Broadband Router For example C\pingRequest time out Destination host unreachable Web Configuration Accessing Web-Based Configuration UtilityMaking the Changes Effective Applying ChangesSystem Overview Router Mode General InformationSystem Overview Bridge Mode WAN Configuration Router Mode Part 1 Configuring general settingsDhcp Client Part 2. Configuring protocol-specific settingsPPPoE Client WAN Configuration PPPoE Client WAN Configuration Bridge Mode Manual ConfigEnabling Bridging Mode LAN Configuration Dhcp Server Router Mode OnlyLAN Spanning Tree Protocol Router Mode Only LAN Configuration Router ModeViewing Current Dhcp Assignments Router Mode Only 11 Dhcp Lease TableWireless LAN 2.4G Configuration Basic ConfigurationWireless Bridge 12 Access Point Mode13 Wireless Bridge Mode Access Control Advanced ConfigurationPage Wireless LAN Security Network AuthenticationWEP Format Minimum CharactersNetwork Key fields Key Length HEX Format Ascii Format 64 Bit Hexadecimal digits Ascii characters 128 Bit15 Wireless LAN Security General Filters Router Mode OnlyConnection Logging LAN MAC Filter LAN Client FilterForwarding Router Mode Only 16 FiltersDescription DMZ IP AddressPort Forwards Application Specific Port ForwardsStatic Routes Administration System ClockManagement Setup Firmware UpgradeCurrent Firmware version field Restore Factory DefaultsSystem Page Troubleshooting Page Interface Power Adapter and Environmental RequirementHardware PhysicalRouter Features WAN Port FeaturesLAN Port Features SoftwareWireless LAN Features Security FeaturesConfiguration and Management Features Technical Support