WLBARGSAP/RouterManualSwitching
7
If you would like to use AP (Access Point) function, please use the switch but- ton in the bottom of the product. The operations are as the below:
(1)Cut off the power.
(2)Switch AP/Router to the left (AP side).
AP | R outer |
(3)Plug in the product.
(4)Now the product is in AP mode. Open browser to access setting page and enter [192.168.1.220] into the address bar, then press [Enter].
**Warrning **
This is a special application. In AP mode, the product stops to generate IP, WAN port doesn’t function and LAN port also becomes a normal hub, so users are recommended to keep its router function.
46