Additional Info
Troubleshooting
Problem | Cause | Solution |
|
|
|
The scanner | No power. | Ensure that iSCAN is equipped with |
does not turn |
| fresh batteries. If powering iSCAN |
on |
| from external power, make sure |
|
| that the external power plug is fully |
|
| inserted into iSCAN’s PC/IF jack. |
|
|
|
Low battery | Low batteries | Recharge rechargeable batteries, |
warning beeps |
| replace alkaline batteries, or plug in to |
and message |
| external power. |
on LCD display |
|
|
|
|
|
Poor or no | Weak signals | Reposition for best reception. |
reception | from distant | Turn SQUELCH |
| stations. | |
|
| |
|
|
|
| Attenuator in | Check performance with and without |
| use on weak | attenuator activated; use setting with |
| signals. | best reception. |
|
|
|
| Strong signal | Check performance with and without |
| overload | attenuator activated; use setting with |
| from nearby | best reception. |
| transmitter. |
|
|
|
|
| Loose or defec- | Inspect antenna and connectors and |
| tive antenna. | correct any problems found. |
|
|
|
| Incorrect mod- | Ensure that proper modulation mode |
| ulation mode | is selected for the type of system |
| selected. | being monitored. If necessary, use |
|
| iSCAN PC Application to change |
|
| modulation mode. See “RX Mode” on |
|
| page 37. |
|
|
|
Scanning | The batteries | Recharge or replace the batteries. |
not available | are low and all |
|
shown on | functions that |
|
display | write data to |
|
| the SD Card |
|
| (including |
|
| scanning) are |
|
| disabled to |
|
| prevent data |
|
| corruption. |
|
|
|
|
Problem | Cause | Solution | |
|
|
| |
The scanner is | Squelch may | Turn the squelch control | |
on but does | not be adjusted | counterclockwise. | |
not scan | correctly. |
| |
The scanner | The SD Card | Use the iSCAN PC Application to | |
does not rec- | is not properly | reformat the card. If using Windows to | |
ognize the SD | formatted. | format the card, the card format must | |
Card |
| be FAT with 32k clusters. | |
|
|
| |
| The SD Card | Press the SD Card into the slot until | |
| may not be | a click is heard and the card is fully | |
| inserted fully. | inserted in the slot. | |
|
|
| |
| The SD Card | Replace with a new SD Card. | |
| may be |
| |
| defective. |
| |
|
|
| |
Init SD Card | The SD Card | Use the iSCAN PC Application to | |
remains when | is not properly | reformat the card. | |
the scanner is | formatted. |
| |
turned on |
|
| |
The SD Card | Press the SD Card into the slot until | ||
| |||
| may not be | a click is heard and the card is fully | |
| inserted fully. | inserted in the slot. | |
|
|
| |
iSCAN does | The USB cable | Connect the USB cable to the scanner | |
not accept | is not plugged | and the computer to proceed. | |
a firmware | into the com- |
| |
upgrade | puter or the |
| |
| scanner. |
| |
|
|
| |
| The USB cable | Use the CD to install the cable drivers. | |
| drivers are not |
| |
| installed. |
| |
|
|
|
Additional Info
52 | 53 |