Setup
Setup
Attaching the Antenna
1.Align the slots on the antenna’s connector with the posts on iSCAN’s connector and slide the antenna in place.
2.Rotate the antenna’s BNC connector clockwise until it snaps in place.
Connecting an External Antenna
To connect an external antenna, follow the installation instructions supplied with the antenna. Use
•For lengths between 50 and 100 feet, use
•For lengths over 100 feet, use RG8.
You also may need a BNC adapter (available at your local RadioShack store).
wWarning: Use extreme caution when installing or removing an outdoor antenna. If the antenna starts to fall, let it go! It could contact overhead power lines. If the antenna touches a power line, touching the antenna, mast, cable, or guy wires can cause electrocution and death. Call the power company to remove the antenna. DO NOT attempt to do so yourself.
Powering iSCAN
Installing Batteries
wWarning: Always power off iSCAN by pressing and holding before removing batteries. Failure to power off iSCAN may cause data loss or memory corruption.
1.Power off iSCAN.
2.Remove the battery compartment cover.
3.Set the Battery Type Selector switch to ALKA for non- rechargeable alkaline batteries or
4.Insert two AA batteries, matching the polarity symbols (+ and
4.Replace the battery compartment cover.
AA | AA |
|
Battery
Type
Selector
wWarning: Never install alkaline batteries with the Battery Type Selector switch set to
Recycle Rechargeable Batteries
Placing rechargeable batteries in the trash can be harmful to the environment. Instead, recycle old rechargeable batteries at your local RadioShack store free of charge. RadioShack participates in the RBRC© battery recycling program, and is committed to preserving the environment and conserving natural resources. Call
Setup
14 | 15 |